How to turn off gauge face on Dakota Digital?
In the Setup menu, navigate to DISPLAYS select TURN REMIND and set to GAUGE. This will activate the turn signals within the gauge face. If OEM is selected it will turn off the gauge face indicators.
How can I change the path of gauge?
The path and name of the specs directory can be changed by using key value pairs in the default.properties file of your project. For more information about default.properties, see Local configuration of Gauge (default.properties). The following is an example of a Gauge specification: For more information about Markdown, see Markdown Syntax.
When do you run the code in gauge?
Every step implementation has an equivalent code as per the language plugin used while installing Gauge. This code is run when the steps inside a spec are executed. In the following example, the two sentences preceded by asterisk, *, are the unordered steps listed inside the Successful search scenario.
Where do I put my specs in gauge?
Every spec can be marked with labels using Tags. When a Gauge project is created and initialized, a specs directory is automatically created at <project_root> with a sample file, example.spec . This sample file helps you understand how to write a specification.
Why does the gauge not work on a Harley Davidson?
The gauge displays NO CAL (no calibration). It will not function if it is installed before the odometer copying process is performed. Verify that the engine OFF/RUN switch is in the RUN position. Turn the ignition switch to the ACCY position and note the odometer reading. Turn ignition switch OFF.
What should I do if my fuel gauge is still on full?
Turn the key on again to check the gauge. If there is still nothing… Check the continuity of the pink wire, (which is the sending wire), from the back of the gauge to the sender. If there is a lot of resistance, run a wire from the gauge to the sender, just touching these wires together for testing purposes.
How do you test an analog fuel gauge?
Testing an analog fuel gauge is pretty simple and should be something you can do fairly quickly! The gauge requires 3 things to operate. 12 Volt Power, Ground to the Battery, and the Sensing Wire coming from the fuel sender in the tank.
What should the gauge factor of a strain gauge be?
Gauge factor is defined as the ratio of fractional change in electrical resistance to the fractional change in length (strain): The Gauge Factor for metallic strain gauges is typically around 2. Ideally, we would like the resistance of the strain gauge to change only in response to applied strain.