Why is my four wheeler just clicking?
Your ATV most likely clicks when you try to start it because of the battery. The reasons for this are numerous, from loose connections to a current draw that drains the battery. If the battery is not the cause, the ATV probably has a faulty starter solenoid.
Why is my Polaris Sportsman 500 not starting?
First, there may be low battery voltage, and owners should try to recharge the battery to 12.8 VDC. Two other problems may be that there are loose connections on the battery or on the solenoid. In either case, owners should check and tighten all connections. If the engine turns over but will not start, it is possible that the ATV is out of fuel.
When did the Polaris Sportsman 500 come out?
Founded in 1954, Polaris Industries first began manufacturing ATVs (all-terrain vehicles) in 1985. This gave the company over 25 years of ATV experience when it released a new model of the Sportsman 500 for 2011.
What to do when your ATV won’t start?
If your ATV doesn’t crank at all when you’re trying to start it, there are a few basic things to look into. 1. Make sure the kill switch/run switch is in the “ON” or “RUN” position. You’d be surprised how often the solution to an ATV that won’t start is forgetting to turn on the kill switch.
What should battery voltage be on Polaris Sportsman 500?
If the engine runs irregularly, stalls or misfires, it is possible that there are dirty or defective spark plugs, which must be inspected, cleaned or replaced accordingly. It is also possible that there is low battery voltage. The 2011 Scrambler 500 battery must be charged to 12.8 VDC.
Why does my Polaris Sportsman 500 not start?
Sounds like a wiring issue, something might be shorting. you should see if you cn pullstart it, i have a polaris sportsman 500 that starts good with pullstart but it doesnt with electric start. it turns over good but doesnt start… not sure whats wrong with it. No critters found or chafed wires.
How did I get a spark on my sportsman 500?
By some miraculous happening i had a spark one day after it had sat in my garage for a week or more & i was able to start it on the pull as we had burnt the starter out but it was missing & back firing a lot. All of a sudden it cleared & revved like a good un but what had i done?
What does it mean when your ATV won’t start?
The solenoid should make an audible “clicking” sound each time you hit the starter. If it does, you know it is getting power, and the problem is likely with the solenoid itself or possibly the starter.
What should I do if my bike wont start?
Charge the battery or replace it if it’s dead. Am easy way to test your battery is by checking the voltage-drop with a multimeter as you try starting the bike. If your fully charged battery drops below 11,5 volts under load (while you crank the starter), it needs to be replaced.