Do you need to remove the pedal commander?
SERVICE NOTE: If you’re visiting a dealership for regular service, you do not need to remove the pedal commander. Just turn it off and tuck it away so that you can put it back into its bracket after your service is complete. What is Pedal Commander trying to say on this one? Well, it probably voids some type of warranty after installing it.
Where to mount the pedal commander on a 4Runner?
Preferably, you want to mount the Pedal Commander somewhere on the dash of your 4Runner to where you can easily adjust the controls while driving on the fly. Use the include alcohol wipes to clean the area where you would like to mount the bracket. Apply the Velcro to the bracket and clean area.
What are the different modes of the pedal commander?
The Pedal Commander offers four program selections and they vary from eco-mode, city, sport, and sport+ which all have their own set of features and benefits. Each mode has nine different sensitivity levels and up to 36 levels in total, which can be accessed by pressing the program button.
Can a power commander be attached to a vehicle?
Attached to your vehicle as a piggyback device that optimizes your air/fuel ratio, this device can then be easily uninstalled to return to stock settings. For tuning, our Power Commander is a truly powerful device, but its tracking and monitoring is what truly sets it apart.
Can a Dynojet power commander connect to a computer?
For tuning, our Power Commander is a truly powerful device, but its tracking and monitoring is what truly sets it apart. It easily connects to any computer through USB and has a -100/+250% fuel change range for more adjustment possibilities.
How do you adjust the power commander on a Harley Davidson?
Adjusting Your Power Commander Your Power Commander has been programmed with a base map for your application. You can adjust the base map or install an alternate map using your Computer. Please refer to the supplied CD-Rom for more information. You can also adjust your Power Commander using the face plate buttons as described below. 1.
Where is the power commander on a Harley Davidson Twin Cam 88?
1. Remove the seat. 2. Remove the left and right side covers. 3. From the left side of the bike route the Power Commander III cable over the frame rail and under the stock wiring harness in the area of the section of the seat. Make sure the seat does not put pressure on the Power Commander III cable. 4.