What does the code p0118 mean on the ECM?
This data is sent to the ECM, which uses this data to regulate the air to fuel ratio, cooling fans, and ignition spark timing needed by the engine. Code P0118 is the result of the ECT sensor indicating a high voltage input from the coolant temperature circuit. (typically over 4.7V)
What are the p1353 and p1356 codes?
Codes P1353 and P1356. 1 jaceddie Junior Member. 928. 28. 1. I have a 2004 Ultra that had the 1356 code “Rear cylinder no Combustion EFI” come up last week. Today, the 1353 2 glider Veteran Member. 3 wildspirit97 Guest. 4 jaceddie Junior Member. 5 Fisher Account Removed.
Why do I get p1353 on my Harley Davidson?
Thanks Those codes could be caused by the PC or a number of other things also like plugs, plug gap, plug wires, loose plug tip where the wire joins on and even bad wiring on the injectors near the plug.
This data is sent to the ECM, which uses this data to regulate the air to fuel ratio, cooling fans, and ignition spark timing needed by the engine. Code P0118 is the result of the ECT sensor indicating a high voltage input from the coolant temperature circuit. (typically over 4.7V)
Which is p0118 engine coolant temperature sensor high input?
P0340 tps high voltage P0118 engine coolant sensor high voltage P0108 map high voltage P0351 coil primary circuit (no idea what that means..) P0113 IAT high volt… 2001 Saturn SC 1.9 4cyl. 120,000mi. P0118 CTS, P0507 ERGvalve, P0301 misfire #1.
What should the voltage be on an ECT sensor?
You do not need to know all of the inner workings of the computer, just that when you check voltage on the yellow wire (Figure 1) and the engine is cold, you should read high voltage at 3-5 volts and at normal operating temperature the signal voltage should be low around 0.47-1.45 volts, see the below table:
What causes the p0118 OBD-II trouble code?
All our repairs are backed by our 12-month / 12,000-mile warranty. P0118 is the OBD-II generic code that indicates the Engine Control Module (ECM) has seen the ECT sensor output go more than 4.91 V or less than -40°C (-40°F). What causes the P0118 code?
P0340 tps high voltage P0118 engine coolant sensor high voltage P0108 map high voltage P0351 coil primary circuit (no idea what that means..) P0113 IAT high volt… 2001 Saturn SC 1.9 4cyl. 120,000mi. P0118 CTS, P0507 ERGvalve, P0301 misfire #1.
You do not need to know all of the inner workings of the computer, just that when you check voltage on the yellow wire (Figure 1) and the engine is cold, you should read high voltage at 3-5 volts and at normal operating temperature the signal voltage should be low around 0.47-1.45 volts, see the below table: