How to clear codes from diagnostics in Polaris RZR?
Also you DO NOT wait the TPS voltage reading to get to .742 cause that’s when the ECU changes it’s internal fuel map from IDLE to Accelerate mode. If the TPS is TOO high, the ECU gets confused and doesn’t know when it’s idleing.
How to write down voltage reading on Polaris RZR?
Write down the voltage reading. Next press the accelerator pedal ALL the way to the floorboard and take the voltage reading there & write it down. This is the WOT (or FULL SWEEP reading) and should be around 3.7 ish to 3.82.
What is the SPN code on a Polaris?
Now along with the 0 and 8 the SPN code reads 637. Both the 8 and 637 refer to camshaft phase sensor in the diagnostic trouble code table. Do I have a short or is the sensor bad? the unit is running good. If the sensor is bad would it effect the operation? At idle the motor is a little rough but never backfires.
What is the SPN code for Check Engine Lite?
Yes it does. Lite was intermitent and now is on steady. Now along with the 0 and 8 the SPN code reads 637. Both the 8 and 637 refer to camshaft phase sensor in the diagnostic trouble code table. Do I have a short or is the sensor bad? the unit is running good. If the sensor is bad would it effect the operation?
Also you DO NOT wait the TPS voltage reading to get to .742 cause that’s when the ECU changes it’s internal fuel map from IDLE to Accelerate mode. If the TPS is TOO high, the ECU gets confused and doesn’t know when it’s idleing.
What does the error code 0651 on a Polaris Ranger mean?
We just bought a Polaris RZR. The engine light came on and it is giving an 0651 error code. What does this mean? I am not sure you can help. The motorcycle category was the closest. … read more check engine lite (EFI fault) came on on my 2013 Polaris Ranger RZR 800S. Unit is running fine and all levels are good.
Write down the voltage reading. Next press the accelerator pedal ALL the way to the floorboard and take the voltage reading there & write it down. This is the WOT (or FULL SWEEP reading) and should be around 3.7 ish to 3.82.
What does compression mean on a Polaris RZR 800?
My 2011 Polaris RZR 800 transmission does not allow the engine’s compression to slow the vehicle when going down hill ( in H or L) if the gas pedal is not depressed. The only way to have compression s … read more