Why does my Yamaha 700fi Charger not work?
The more common problem is at least one shorted or open coil within the sets. Start the engine and let it idle. Use the multimeter set in the appropriate range to measure around 20 Volts AC (NOT DC). Put one probe on the stator side single white wire and the other probe on one of the white wires on the stator side dual pin connector.
What should I do if my Yamaha Rhino is not charging?
If its still not charging, trace the 3 wires that come from your alternator and connect to your regulator. Disconnect them and use a meter to check between each of the 3 wires. You should get 60-90 volts AC.
What kind of AC does a Yamaha 700fi use?
Put one probe on the stator side single white wire and the other probe on one of the white wires on the stator side dual pin connector. You should see around 20 V AC. Move the probe on the dual pin connector to the other white wire on that same connector.
Is the Yamaha Rhino 700 cc still available?
It was the only side-by-side that Yamaha still offered for 2011 in a 700 cc model. Despite having three different engineering designs since its inception, troubleshooting tips remain mostly consistent across all Rhino models.
The more common problem is at least one shorted or open coil within the sets. Start the engine and let it idle. Use the multimeter set in the appropriate range to measure around 20 Volts AC (NOT DC). Put one probe on the stator side single white wire and the other probe on one of the white wires on the stator side dual pin connector.
Put one probe on the stator side single white wire and the other probe on one of the white wires on the stator side dual pin connector. You should see around 20 V AC. Move the probe on the dual pin connector to the other white wire on that same connector.
Why does my Yamaha Rhino 700 not start?
Went back out to start it and right back to the same starting problems. Turns over over and every once in a while it will fire as if it is going to start but goes back to turning over and over. Any body out there have any ideas before I put it on the trailer and take it to the dealer.
Is the Yamaha 700 running at the end of the street?
Took my 08 700 out this past weekend and it ran great. Decided to take it out for a quick ride around the neighborhood today. Got to the end of the street and it sputtered then died.
Are there any electrical issues with my King Quad?
As you can view the King Quad has many electrical connections. when they get wet. But some more than others. troublemakers. And those areas you should check first. Not just water but corrosion. Doesn’t mean it’s a good connection. have some corrosion. is Snorkels. designed to run deep water. than a set of snorkels.
Why is the fi light flashing on my King Quad?
Changed all that out and now the FI light flashes once every second. Put quad in dealer mode and get -C00 code and FI light stops flashing. Back to user mode and the FI light starts flashing again. ECU works in friend’s quad. Changed temperature sensor, rectifier, ignition coil, air pressure sensor, fuel pump, fuel pump relay, added chassis ground.
Why is the starter on my King Quad not working?
designed to run deep water. than a set of snorkels. supply and the fuse that burns out. Most think it’s not working and must be a fuse. it all work. the electronics as well Relays and Lights. Your starter is the biggest draw of both power and ground and it has it’s own ground that comes right off the battery to the engine casing.
As you can view the King Quad has many electrical connections. when they get wet. But some more than others. troublemakers. And those areas you should check first. Not just water but corrosion. Doesn’t mean it’s a good connection. have some corrosion. is Snorkels. designed to run deep water. than a set of snorkels.
Why does my Yamaha 700fi battery not charge?
700fi will not charge. Change the rectifer and still only battery voltate. I need some help here. What wire do you check at the rectifier that is coming from the stator?
Changed all that out and now the FI light flashes once every second. Put quad in dealer mode and get -C00 code and FI light stops flashing. Back to user mode and the FI light starts flashing again. ECU works in friend’s quad. Changed temperature sensor, rectifier, ignition coil, air pressure sensor, fuel pump, fuel pump relay, added chassis ground.
designed to run deep water. than a set of snorkels. supply and the fuse that burns out. Most think it’s not working and must be a fuse. it all work. the electronics as well Relays and Lights. Your starter is the biggest draw of both power and ground and it has it’s own ground that comes right off the battery to the engine casing.