How do you check the oil on a 2003 Fatboy?
Place the motorcycle on a vertical stand or sit on the motorcycle and tilt it upright. Start the motor and let it to warm up for a few minutes to reach operating temperature. This will allow the oil to heat up and expand slightly. Hold the bike fully vertical to pull oil from the engine’s sump for an accurate reading.
What is a jiffy stand?
The jiffy stand is Harley-Davidson’s name for the item that permits a motorcycle to be parked leaning to the left side but with no risk of falling over.
How do you remove the ignition switch on a Harley Davidson?
End of dialog window. This is a modal window. This modal can be closed by pressing the Escape key or activating the close button. This is a modal window. This modal can be closed by pressing the Escape key or activating the close button. We have been asked a couple times about Harley-Davidson ignition switch knob removal in our Harley Tips section.
Is there a problem with the ignition on a Harley Davidson?
Thanks george,but its none of the above you wrote,My Harley is garage,I finally found out it was a contact inside ignition that had broke away due to flat keys riggling about because of vibration of engine,all 2015 wide glides also have same problem and have been recalled,over 3000 bikes.
How to replace an ignition switch on a Sportster?
In regards to your question- We do not have a video that demonstrates replacing an ignition switch on a Sportster. You may be referring to a touring video. Remove your ignition switch. Trace wires to the 1st junction and disconnect wire connections.
How do you know if your Harley Davidson has a trouble code?
The test wire must be removed from the data connector and the ignition switch turned OFF or the check engine lamp will continue to flash codes. A historic trouble code resides in the memory of the ECM until the code is cleared by use of the Scanalyzer or a total of 50 trips has elapsed.
The test wire must be removed from the data connector and the ignition switch turned OFF or the check engine lamp will continue to flash codes. A historic trouble code resides in the memory of the ECM until the code is cleared by use of the Scanalyzer or a total of 50 trips has elapsed.
How do you test a Harley Davidson coil?
The crank sensors don’t always set a code so it;s a crap shoot but I would lean towards the sensor rather than coil myself. Test the coil with a ohm meter. the readings should be the same on both sides if it is a dual. if it is a single look up the readings.
What does a trip code on a Harley Davidson mean?
A “trip” consists of a start and run cycle, the run cycle lasting at least 30 seconds. After the 50 trip retention period, the trouble code is automatically erased from memory (that is, assuming no subsequent faults of the same type are detected in that period).
How many miles is a 2003 Dyna superglide?
Oh yea the bike is a 2003 Dyna Superglide with over 55,000 miles on it. It got me home I didnt ride for 2 weeks went out to start it on a nice day and thats when the problem started. Thanks.