How to rebuild a race car shock reservoir?
A8 – Install the shaft assembly into the shock body. Make sure the piston band stays in the groove and is not pinched. A9 – Top off the fluid to within 10mm of the top of the shock body. A10 – To bleed the shock, push down firmly and pull up slowly until no more bubbles show up on the compression stroke.
Where does the oil leak come from in a car?
The oil pan is located at the bottom of the engine. It will be damaged over time as debris hits the bottom of the pan and leaves dents. If you have an aluminum oil pan, there is a risk that you hit something under the car, which caused cracks in the oil pan where the oil leaks from.
How to set seal on shock bladder reservoir?
A13 – Push in the seal head using a Seal Head Setting Tool (TSSS Series) until the O-ring seals. Maintain pressure on the top of the seal head. A14 – Once the O-ring seals on the body you will not be able to insert the seal head in any further. This is because you are pushing against the reservoir pressure.
How are reservoir shocks different from piston shocks?
These shocks use either a bladder or a floating piston to separate the oil and nitrogen in the reservoir. Most of the procedure is the same. Assembly-only is covered in the Piston Style Reservoir Shock Rebuild. CAUTION: IF YOU ARE UNFAMILIAR WITH REBUILDING AND REVALVING SHOCKS, STOP!!!
What to do when you put acid on a scooter?
Put gasket cover inside the trunk and trunk its install. Once you have all the parts attached, and you’ve waited about 30 minutes after adding acid to the battery, you’ll be ready to start the scooter. Turn ignition switch to the on position. Make sure the kill switch is on the on position. Press both brake levers.
What to do if your scooter runs out of gas?
It may be necessary to prime the carburetor before attempting to start it when the scooter is brand new, has been inactive for a long period of time, cold engine or runs out of gas. This is accomplished with the primer pump bowl located at the bottom of the carburetor.
What to do if you have oil in the coolant reservoir?
The first thing you should do if you notice oil in the coolant reservoir is to pressure test the system. If you pressure-tested the system and everything seems fine, you might want to remove the coolant from the reservoir and keep driving the car to monitor if any new oil appears in the reservoir.
Where are the rubber gaskets on a scooter?
On the rear rack of the scooter, put the rubber gaskets on the bottom of the metal rear rack. Put the metal bracket underneath of rear rack of the scooter.