How do you move a radiator on a King Quad?
You must lift up your Rad slightly as there is a small pin on the bottom of the Radiator to assist on holding the radiator in place. Once you give it a slight lift then drop it down to the open spot from where your winch was located.
Do you mix coolant and water with radiator fluid?
To mix the radiator fluid properly, mix the coolant and distilled water in a 50/50 proportion. Fill an empty radiator fluid bottle halfway with water and then fill the rest of the bottle with radiator fluid.
How to put engine coolant in a Suzuki Grand?
3) Loosen the drain plug attached to the lower part of the radiator and drain the engine coolant into a suitable container. 4) Reinstall the reservoir and fill it with engine coolant to the “FULL” line. 5) Tighten the drain plug on the radiator, fill the radiator with engine coolant and install the radiator cap.
What kind of coolant do you put in an ATV radiator?
Screw the bolts back on and fill the radiator with water. Remove the bolts again to let the water drain. Repeat this process until the water drained from the radiator is clean. Premix your ATV coolant with distilled water. A 50/50 mixture is the most common. You can also add anti-freeze and Water Wetter if needed.
To mix the radiator fluid properly, mix the coolant and distilled water in a 50/50 proportion. Fill an empty radiator fluid bottle halfway with water and then fill the rest of the bottle with radiator fluid.
3) Loosen the drain plug attached to the lower part of the radiator and drain the engine coolant into a suitable container. 4) Reinstall the reservoir and fill it with engine coolant to the “FULL” line. 5) Tighten the drain plug on the radiator, fill the radiator with engine coolant and install the radiator cap.
Screw the bolts back on and fill the radiator with water. Remove the bolts again to let the water drain. Repeat this process until the water drained from the radiator is clean. Premix your ATV coolant with distilled water. A 50/50 mixture is the most common. You can also add anti-freeze and Water Wetter if needed.
How do you change the coolant in a mrcycle?
Remove the drain bolt and sealing washer and allow the coolant to drain into a suitable container. Install the coolant drain bolt with a new sealing washer. Tighten the drain bolt securely. Remove the siphon hose to drain the coolant out of the reserve tank. On some models the reserve tank may need to be removed.