How does the starter relay work on a Harley Davidson?
When the driver engages the ignition switch, the energizing circuit of the relay is closed and the electromagnet energizes. The magnet pulls a contact into the closed position and high current is available to the starter. Release the ignition switch to de-energize the electromagnet and stop current flow to the starter.
What happens when the starter fails on a Harley Davidson?
The magnet pulls a contact into the closed position and high current is available to the starter. Release the ignition switch to de-energize the electromagnet and stop current flow to the starter. * Failure of the energizing circuit. The relay is effectively “dead” when this circuit fails. Attempting to start the engine will be unsuccessful.
How do you retract starter solenoid on Harley Davidson?
Connect the free clip to the starter relay terminal on the left side of the starter solenoid. The solenoid pinion gear, exposed at the inner face of the solenoid, should click and retract into the starter housing. The starter solenoid is defective if the pinion gear does not retract.
What to do if you have a bad starter relay?
Safety first: always disconnect the battery cable before touching the relay. Tools or wet fingers that happen to touch both sides of the contact circuit may cause sparking and could turn over the engine, creating a very dangerous situation. Gain access to the relay. Disconnect the wires, noting their positions. Remove the relay from its mount.
What are the problems with a Harley Davidson starter?
Harley Davidson Common Starter Problems Summary and Fixes – YouTube There are a few very common HD Starter problems. It starts with pushing the start button on only hearing a There are a few very common HD Starter problems. It starts with pushing the start button on only hearing a Skip navigation Sign in Search Loading…
How to check the electrical system on a Harley Davidson Softail?
Record the code number to research possible causes. Press and hold the odometer button to clear the code, and then shut off the ignition to exit the menu. Repeat the process to check the other systems.
Where are the black wires on a Harley Davidson Softail?
The black wire connects to the main wiring harness ground near the battery. The other three black wires go to the stator. Make sure these wires are all clean and tight. Spray some electric terminal contact cleaner on the connections to promote conductivity. To test the stator, you’ll need a volt meter set to AC volts.
What to do if your Harley Davidson voltage regulator is not working?
You can troubleshoot the issue in your garage and find a solution to the problem without visiting a repair shop. If your Harley Davidson voltage regulator problems are giving you some tough times, this article will guide you through diagnosing the issue while suggesting solutions to fix it. What’s the Possible Reason to Face This Problem?
What is a solenoid in a starter relay?
The starter relay, usually called a solenoid in automotive applications, is simply an electronic switch. Relays can be electro-mechanical or solid-state. The theory of operation is the same for both. Two circuits are necessary for the relay to operate.