What do you need to replace a clutch on a motorcycle?
For this job you will need an oil drain pan, repair manual, replacement clutch plates, new clutch springs, clutch cover gasket, motorcycle engine oil and some basic hand tools. A dial caliper is only needed if you intend to reuse any of the original clutch parts. If you are due for a new oil filter soon, now is a good time to change that, as well.
Do you have to replace the clutch plate on a Suzuki?
Some replacement plate kits require you to remove the spring, so be sure to check with the manufacturer of the replacement clutch plates to see if your judder spring remains in place or gets removed. Our Suzuki has a thick friction plate against the innermost part of the clutch basket. The remaining ones are all the same thickness.
Do you need to replace the springs on a clutch?
The replacement springs we are installing are 15 percent firmer than stock, which could result in a slightly heavier clutch lever feel, but will ensure the new clutch plates do not slip under hard use. If you prefer a lighter clutch feel, I recommend going with stock replacements.
How to replace the clutch on an Audi A4 professional?
The wiring loom was unclipped and then secured. Above this switch was one end of the gear selector rod. The retaining bolt was removed and put to one side (Fig 2). On the left, the clutch slave cylinder and the other end of the gear selector rod was located. The hydraulic hose was clamped to the slave cylinder to prevent any fluid loss.
When do I need to replace my Clutch?
If you are replacing your clutch, pressure plate, or flywheel, here are 5 tips to do it right. if your clutch is worn, burnt, or slipping, replacement may be needed. Or you might be considering a performance clutch. Whatever the reason for you to replace your clutch, you want to be sure you replace it correctly.
What should be included in a clutch kit?
A clutch kit includes a new or remanufactured clutch disc, pressure plate and release bearing. A kit is the best way to go because all of the parts are sourced from the same supplier and are matched so the installed height will be correct. Mismatched parts can sometimes cause engagement and release problems.
Some replacement plate kits require you to remove the spring, so be sure to check with the manufacturer of the replacement clutch plates to see if your judder spring remains in place or gets removed. Our Suzuki has a thick friction plate against the innermost part of the clutch basket. The remaining ones are all the same thickness.
How do you replace the transaxle on a clutch?
To replace the transaxle, align the transaxle with the clutch disc splined hole. Gently move the transaxle forward until the input shaft glides into the clutch disc’s splined hole.