What do you need for a racing ignition?
Connect all necessary ignition earth cables . Connect the stator connector to the ignition coil. Connect the ignition switch (red connector) and, for ignitions with two ignition curves, the ignition curve selector switch (green connector). In racing, cut-out switches are often used as ignition switches.
What happens when you change the ignition value?
Changing the timing value up or down changes the engine speed up or down for the optimum ignition timing. The engine speed operating range affects where the timing is the best. Increasing the timing advance raises the high-end power, reducing the low-end. Decreasing the timing advance raises low-end power, reducing the high-end.
What should the ignition timing be for nitro fuel?
Nitro fuels run a lot more fuel volume and, as a result, need more timing. Example: For a blown alcohol engine on low percentages of nitro at a low level of enrichment, 40 degrees of timing was typical. On high percentages of nitro at a high level of enrichment, 55 degrees of timing was typical.
How do you start a PVL racing ignition?
Turn the crankshaft to the static ignition advance and fix it in this position (piston stop). Insert the rotor and turn it on the crankshaft stub until the magnetic poles form an axis with the charging coil . The guide marks on the stator and rotor are close together. Screw down the rotor in this position.
What do you need to know about ignition lock assembly?
However, from time to time, the ignition lock assembly or small parts inside this device can complicate the situation. The ignition lock assembly is a tumbler and key mechanism that is used to trigger power supply to auxiliary components and engage the starter motor to begin the ignition process.
How do you install a new ignition lock?
Step 9: Install the new ignition lock cylinder. In most cases, installing the new ignition lock cylinder is very simple. However, you should refer to your vehicle’s service manual to find out anything particular to your vehicle.
How do you remove the ignition lock cylinder?
With the key still inserted, gently remove the ignition lock cylinder from the lock body. Step 8: Loosen the two screws on top of the lock body. You should see two screws that are located on the top of the lock body after you’ve removed the ignition lock cylinder. Loosen these screws about four full turns.
Where is the cover on an ignition lock?
On most vehicles, there is a plastic or metal clip that is over the ignition lock cylinder. To remove this, remove the small screw that holds this cover in place, typically located on the bottom of the switch. Once the screw has been removed, carefully slide the cover off the ignition lock cylinder.