Can you change motorcycle handlebars?
Swapping in a new set of handlebars can change the aesthetics, ergonomics, and the steering feel and performance of the motorcycle all in one shot. It can be done in just a day in the garage, too, so DIYers with a little passion can switch things up fairly easily.
Do I need longer cables for Ape Hangers?
A longer cable might be okay as it covers up the slack of your motorcycle, but a shorter cable won’t fit properly and make you purchase another one in its place. …
What gauge is Harley wiring?
The stock Harley wires are also 18g.
What is wire pulling lubricant?
What is a cable pulling lubricant? A cable pulling lubricant is a specialty product designed to reduce the friction of a cable rubbing on a conduit. The friction reduction lowers the force required to pull the cable into the conduit. This reduces the tension (tensile stress) on the cable when it is installed.
Can you change the handlebars on a Harley Davidson?
CHANGING YOUR HANDLEBARS HAS NEVER BEEN EASIER! The new Custom Dynamics® Handlebar Extension Wiring Kits make changing the handlebars on your Harley-Davidson® Touring model easier than ever! Available for 12″ Handlebar Extension and 15″ Handlebar Extension!
Do you need a handlebar extension wiring kit?
Handlebar Extension Wiring Kits also available for Handlebar Extensions on CanBus Harley-Davidson® Models. 2008-2013 Harley-Davidson® Electra Glide®, Ultra Classic®, Ultra Limited, Road King®, Street Glide®, Road Glide®, Road Glide® Ultra and Tri-Glide® models (including CVO™)
When to isolate a handlebar switch for ohms?
An individual wire, handlebar switch or circuit has to be isolated whenever testing for ohms or continuity. That is the circuit cannot be powered or grounded in any way. It must be complete and uninterrupted on its own.
When to double check a handlebar switch test?
It can also be very helpful to double check your work when doing an extensive wiring procedure such as internally wiring handlebars, replacing a main harness, or simply changing signal light housings. Remember, a wire or circuit can have continuity but if ohms resistance is too high, the function will fail to operate, or not operate correctly.
Do you need to replace handlebars on a Harley Davidson touring?
The stock handlebars on the Harley Davidson Touring are designed for comfort. However, not every rider is built the same. Replacing the handlebars allows you to modify the ride to however fits you and your size.
How do you install handlebars on a bike?
Tighten the four screw holding the handlebars in place. Make sure to sit on the bike and really try to move the bars to insure they are tight. Install the TGS, reconnect the wires, then install the grips. Install the brake and clutch assemblies, then install the switches. Connect the wires in the headlamp assembly. Reinstall handlebars’ cover.
An individual wire, handlebar switch or circuit has to be isolated whenever testing for ohms or continuity. That is the circuit cannot be powered or grounded in any way. It must be complete and uninterrupted on its own.
How to test a handlebar switch on a Harley?
Grab a test light and a multimeter. Play around with them a little bit. Electrical theory is not something that you will grasp immediately, so start with trying some easy tests. If you approach things safely, there is nothing that should intimidate you.