How do you unclog a clogged air conditioner?
DIRECTIONS:
- Turn off the power to your HVAC unit.
- Find your AC drain line.
- Push the stiff, thin brush into the end of the drain line.
- Attach the end of your wet/dry vacuum to the end of the AC drain line.
- After you’ve run the vacuum for about a minute, remove the wet/dry vac and head indoors.
- Locate the vent tee.
How do you clean AC sludge?
You do that by pouring a 1/4 cup of distilled vinegar through the AC condensate drain line. We recommend distilled vinegar because its acidity clears the clog faster. You may also use hot water, dish soap, or peroxide if you cannot stand the smell of vinegar.
How do I unclog the AC drain on my Mitsu endeavor?
You may need to unclog your AC drain with a wire or clothes-hanger. The drain is located on the firewall. There is an opening that you can insert a wire thru. To thread this wire into the rubber hose, angle slightly downward. I show you how on this 2005 Mitsubishi Endeavor Loading…
Where is the drain located on a Mitsubishi Endeavor?
The drain is located on the firewall. There is an opening that you can insert a wire thru. To thread this wire into the rubber hose, angle slightly downward. I show you how on this 2005 Mitsubishi Endeavor Loading…
Where does the condensation go in a Mitsubishi?
If this occurs, the HVAC case may fill up with condensation and overflow onto the passenger’s side floorboard. In some cases, it can overflow into the blower motor.
Why does my HVAC overflow on my Mitsubishi?
A Mitsubishi owner may complain of water on the front driver’s side floor of the vehicle. The HVAC drain tube can become blocked by internal foam packing material or by external debris entering the front cowl area. If this occurs, the HVAC case may fill up with condensation and overflow onto the passenger’s side floorboard.
What to do if HVAC blockage on endeavor?
On Endeavor models built only prior to July 20, 2004. If external debris was found inside the HVAC case, and one has not been installed as part of a prior repair, install a new, improved front deck (cowl) garnish to prevent future entry of debris. Later models were built with the garnish ( see Fig. 4 ).
If this occurs, the HVAC case may fill up with condensation and overflow onto the passenger’s side floorboard. In some cases, it can overflow into the blower motor.
A Mitsubishi owner may complain of water on the front driver’s side floor of the vehicle. The HVAC drain tube can become blocked by internal foam packing material or by external debris entering the front cowl area. If this occurs, the HVAC case may fill up with condensation and overflow onto the passenger’s side floorboard.