What are the rules for the drive cycle?
– MIL must be off. 1) Idle vehicle for five minutes (to reach closed loop operation). 2) Drive with a steady vehicle speed between 40 & 60 mph for 8 minutes. – MIL must be off. – MAP must be between 0-60 KPa. – Engine speed between 500-850 rpm. – ECT is above 180º F (90º C). – No misfire temporary (pending) or matured fault present.
What are the rules for the OBD drive cycle?
1) Idle vehicle for five minutes (to reach closed loop operation). 2) Drive with a steady vehicle speed between 30 and 45 mph for 2 minutes. – MIL must be off. 1) Idle vehicle for five minutes (to reach closed loop operation). 2) Drive with a steady vehicle speed between 40 & 60 mph for 8 minutes. – MIL must be off. – MAP must be between 0-60 KPa.
What’s the drive cycle procedure for a Dodge?
Driving Procedure 1) Warm engine up for five minutes (must reach closed loop) 2) Drive (with steady throttle) at a speed between 40 and 60 mph for 8 minutes. 3) Stop and idle for 3 minutes.
Is the drive cycle related to the cel code?
The Drive Cycle is separate but related to the CEL codes. There are several “Monitors” that need to be set. They are EVAP, Catalyst, and others.
– MIL must be off. 1) Idle vehicle for five minutes (to reach closed loop operation). 2) Drive with a steady vehicle speed between 40 & 60 mph for 8 minutes. – MIL must be off. – MAP must be between 0-60 KPa. – Engine speed between 500-850 rpm. – ECT is above 180º F (90º C). – No misfire temporary (pending) or matured fault present.
1) Idle vehicle for five minutes (to reach closed loop operation). 2) Drive with a steady vehicle speed between 30 and 45 mph for 2 minutes. – MIL must be off. 1) Idle vehicle for five minutes (to reach closed loop operation). 2) Drive with a steady vehicle speed between 40 & 60 mph for 8 minutes. – MIL must be off. – MAP must be between 0-60 KPa.
How to perform a basic drive cycle-repairpal?
The Drive Cycle and Emissions Readiness Monitors have, for the most part, stopped this unethical tactic. Here are step-by-step instructions on how to perform a basic, yet very effective, drive cycle that will complete the readiness monitors for your vehicle’s emissions control system.