How do you remove a bolt from a Mercury Sable?
Use a wrench—this bolt is normally 10mm on all model years of the Mercury Sable. Remove the two large bolts and nuts using an 18mm socket and the air gun. Remove the bolts by hand and separate the strut from the spindle by pushing them apart. Remove the three 13mm nuts on the top of the fender well under the hood.
How do you remove brake line from Mercury Sable?
Lift the hood of the vehicle. Remove the brake line where it is attached to the lower part of the strut. Use a wrench—this bolt is normally 10mm on all model years of the Mercury Sable. Remove the two large bolts and nuts using an 18mm socket and the air gun. Remove the bolts by hand and separate the strut from the spindle by pushing them apart.
How do you replace a broken lug nut stud?
Use your fingers to pull the broken bolt from the rear of the hub flange. The replacement bolt was a stock part from a local auto parts supplier. To install the new bolt into the bolt hole, the wheel must be turned to align the hole with a slot on the rear of the hub flange, which provides the clearance to thread it through.
How do you remove bolts from a Fender?
Remove the two large bolts and nuts using an 18mm socket and the air gun. Remove the bolts by hand and separate the strut from the spindle by pushing them apart. Remove the three 13mm nuts on the top of the fender well under the hood.
How to remove a stubborn nut or bolt?
How to Remove a Stubborn Nut/Bolt Step 1: Use Some Muscle. Try a 6-point wrench or socket on your seized nut/bolt. Start by rocking the bolt by tightening… Step 2: Clean It Up. If using some muscle on the bolt does not allow it to budge don’t be discouraged, as there’s a few… Step 3: Leverage.
What’s the best way to remove a split nut?
Back off the nut splitter screw and clean the bolt of the split nut. Try adding more penetrating oil to the newly exposed bolt threads, then use one of the other methods described above to remove the bolt. With the nut removed, the bolt should be much easier to remove.
Can a rusted bolt on a corvette be removed?
(Image/Corvette Forum) A rusted, seized bolt or nut can turn an easy project into a nightmare. In fact, mechanics have been known to hold a lucky rabbit’s foot or refuse to work on Friday the 13 th for that very reason. But removing a stuck bolt doesn’t rely on luck—it relies on the proper preparation and tools. Plan Ahead.
What’s the best way to remove a spinning bolt?
Apart from a wrench, a vice grip is also a tool that you can use to try and pry the spinning nut and bolt out. Another way is to use a pair of pliers or some other mechanism to hold the head of the bolt while you screw the nut out of place. Push the flat end of the screwdriver under the nut and try and release the nut out of its place.