How do you replace a cold water line in a water heater?
Replace Water Heater Supply Lines. Identify the cold water supply line. There should be a “C” or “Cold” embossed in the water heater where the cold water supply line attaches. There will also be a crank knob, similar to the valve on an outdoor hose, either on the wall or along the copper tubing that the other end of the cold line attaches to.
How to remove a heater hose quick connect on a GM?
In this video I will show y’all how to remove a heater hose quick connect on a Chevrolet Silverado. Also applies to suburban, Tahoe etc… with the simple use of a quick connect tool this is a simple job. Just make sure the coolant is not hot. Make sure the coolant is cool. Loading…
How do you drain a hot water supply line?
Drain the supply lines by running both hot and cold water into the kitchen sink. Allow hot and cold to run for a few minutes each. Pull up on the pressure release valve. Hold the lever up for a few seconds to allow the inner tank pressure to subside. Loosen the nuts on both ends of the cold water intake supply line and hot water output line.
When do I need to replace my water heater?
The water heater should be replaced if the tank itself is leaking. Avoid hazards associated with working on water heaters. Mop up any puddles from leaking lines and move with caution if the unit is in a confined space.
How do you replace a hot water supply line?
Hold the lever up for a few seconds to allow the inner tank pressure to subside. Loosen the nuts on both ends of the cold water intake supply line and hot water output line. Use counterclockwise turns with a pipe wrench or slip-slit pliers. The nuts may be very tight. Keep the wrench or pliers level with threads to avoid damaging them.
How do you drain cold water from a water heater?
Turn off the cold water supply valve connected to the cold intake line. Turn the knob clockwise until it tightens. Drain the supply lines by running both hot and cold water into the kitchen sink.
Where is the cold water line on a water heater?
Identify the cold water supply line. There should be a “C” or “Cold” embossed in the water heater where the cold water supply line attaches. There will also be a crank knob, similar to the valve on an outdoor hose, either on the wall or along the copper tubing that the other end of the cold line attaches to. That’s the cold water supply valve.
The water heater should be replaced if the tank itself is leaking. Avoid hazards associated with working on water heaters. Mop up any puddles from leaking lines and move with caution if the unit is in a confined space.