What should I do if my Ford p0102 code comes back?
Reset code and drive vehicle. If the code comes back, it may be necessary to replaced the mass air flow sensor. The cost to diagnose the P0102 FORD code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type.
What does the a stand for in a p0021 engine?
The “A” camshaft is either the intake, left, or front camshaft. A P0021 engine code is basically the same as a P0011 code, except this is for Bank 2, not Bank 1.
What is the cause of engine code p0011?
What Is The Cause Of Code P0011? 1 Engine oil is dirty 2 Engine oil is too low 3 Engine oil is incorrect viscosity 4 Camshaft variable valve timing control solenoid failure 5 Camshaft phaser is seized in the advanced position 6 Continuous oil flow to Variable Camshaft Timing chamber
What are the symptoms of the p0012 OBD-II code?
The variable camshaft timing (VCT) oil control valve (OCV) stuck in the open position. The camshaft phaser is damaged and stuck in the retarded position. Oil flow problems to the VCT piston and phaser. What are the symptoms of the P0012 code? The ECM will turn on the Check Engine Light if the timing cannot be commanded to move.
What Is The Cause Of Code P0011? 1 Engine oil is dirty 2 Engine oil is too low 3 Engine oil is incorrect viscosity 4 Camshaft variable valve timing control solenoid failure 5 Camshaft phaser is seized in the advanced position 6 Continuous oil flow to Variable Camshaft Timing chamber
What causes the p0021 OBD-II trouble code?
P0021 is the OBD-II generic code indicating that the Engine Control Module (ECM) has determined that the bank 2 intake camshaft is more advanced than what the ECM has commanded it to be. This over advanced condition could be during advancing, or retarding of the camshaft timing. What causes the P0021 code?
What does the p0018 code on Bank 2 mean?
What the P0018 code means. P0018 is the OBD-II generic code indicating that the camshaft position sensor A for bank 2 does not correlate to the signal from the crankshaft position sensor.
What does p0021 stand for in Nissan Frontier?
Code: P0021 = Intake Valve Timing Control Solenoid Failure, Bank 2 (Drivers side of engine) Symptoms: Rough idle (below 1000rpm particularly), truck runs like rubbish, SES light (Service Engine Soon). Problem: The solenoid that controls the valve timing has failed or is running intermittently and is fixing to fail.