What to do if your MerCruiser water pump goes out?
If your engine is equipped with an oil, power steering, fuel or engine cooler these will most likely be the areas for debris to become trapped. You should remove the hoses from the thermostat housing to the supply pump outlet as well as the pump inlet hose and backflush all the way out of the sterndrive to ensure there are not any restrictions.
When to replace water pump on Ford Duratec?
Luckily enough the water pump had been replaced at 85k in November of 2015, after complaints of no heat and rough idling above 2000 RPM. Currently the car has 101k on it, so if the minimum of failure expectancy of 65k miles holds true I have about 40k miles before it needs to be replaced (again).
Can a Mercury Sable have a coolant leak?
Timing Cover Coolant/Antifreeze Leak Summary: It is common for a high mileage Ford Taurus or Mercury Sable to develop a coolant leak on the passenger side of the engine. At first you may notice coolant slowly disappearing, but the leak will eventually get to the point that you need to fix it.
When to replace the impeller on a water pump?
It is important to realize that even with a new impeller just a small amount of “scoring” to the pump body can effect the output flow of the pump significantly. If you are replacing the impeller due to overheat issues versus routine maintenance, go ahead and replace the pump body as well.
Where can I buy a Mercury outboard water pump?
Choosing the right Mercury outboard water pump or Mercury outboard impeller can be a real hassle, so go ahead and reach out to one of Wholesale Marine’s dedicated customer service representatives.
How do you change a faulty water pump in a Mercury Villager?
Make sure to change out a faulty water pump in your Mercury Villager to keep the engine operating normally. Place a drain pan underneath the radiator. When the engine is cool, drain the cooling system from the radiator into the pan. Disconnect the negative battery cable and the radiator hoses and take out the drive belts and remove the fan shroud.
What kind of impeller does a mercury water pump use?
Water Pump Kit for Mercury by Sierra Kit Includes: Sie-18-3007 Impeller Sie-18-3118 Upper Pump Housing Sie-18-2945 Drain Gasket Sie-18-2823 Lower Water Pump Base To Face Plate Gasket Sie-18-2824 Upper Face Plate To Body Gasket Sie-18-2825 Water Pump…
What kind of water pump do I need for my Boat?
That’s why Wholesale Marine always suggests going with Mercury outboard water pumps with replacement Mercury outboard impellers to ensure a long lifespan for your boat’s engine. We have an extensive selection of full Mercury outboard water pumps, as well as the replacement parts and kits that go with it.