How do I clear my dash lights?
How to Reset the Warning Lights on the Dash
- Open the hood of your vehicle.
- Loosen the nut that holds the negative terminal to the battery with the pliers.
- Completely remove the cable from the negative battery terminal.
- Leave the battery disconnected for 10 minutes to ensure that the computer is fully reset.
Is there an oil reset light on the dashboard?
Most vehicles manufactured recently are required to have oil reset light on the dashboard. It also needs to have a computer which counts the number of miles you cover at specific intervals and gives you a notification of oil change when necessary.
How do you turn off the oil change light?
Press and hold the stem for 10 seconds, or until the icon begins flashing. Release the stem and hold “select” again for five more seconds. The oil change light should disappear until the next time a change is due. If it doesn’t, then repeat these steps.
How to reset a GMC oil change light?
The following instructions cover the model year 2005, as well as older GMC products and Chevrolet vehicles without a vehicle information center (VIC). To reset the oil change light, follow these two steps: Slip behind the wheel and close all the doors. Insert the key in the ignition and turn the key to the accessory position.
Is it possible to reset the warning lights on the dash?
This will result in a warning light appearing on your vehicle’s dashboard. After the repair is complete, however, it may still be necessary to reset your the computer in order for the warning light or lights to disappear. Fortunately, this process is fairly simple. Open the hood of your vehicle.
Most vehicles manufactured recently are required to have oil reset light on the dashboard. It also needs to have a computer which counts the number of miles you cover at specific intervals and gives you a notification of oil change when necessary.
Press and hold the stem for 10 seconds, or until the icon begins flashing. Release the stem and hold “select” again for five more seconds. The oil change light should disappear until the next time a change is due. If it doesn’t, then repeat these steps.
The following instructions cover the model year 2005, as well as older GMC products and Chevrolet vehicles without a vehicle information center (VIC). To reset the oil change light, follow these two steps: Slip behind the wheel and close all the doors. Insert the key in the ignition and turn the key to the accessory position.
How do you reset the oil change light on a Jeep Wrangler?
For certain Jeep products, including the Wrangler, how to reset an oil change light is as follows: Insert the key into the ignition and turn it to the “on” position without starting the engine. Depress the gas pedal slowly three successive times within 10 seconds. At this point, the system should have reset.