How to diode a dashboard indicator warning light?
The simple solution is to remove the bulb from the dashboard indicator warning light. This isolates the left and right indicator circuits and so prevents the cross-talk between the two sides.
What do you need to know about an indicator switch?
You should now be able to see the indicator stalk switch. The stalk may perform other functions apart from operating the indicators, in which case you will find several wires leading to it. Refer to the wiring diagram in your service manual to identify the indicator wires.
What does the wear indicator on the brake pads mean?
The wear indicator is a small metal tab fastened to the brake pad. When the brake pads are worn down and need replacing, this metal tab starts to drag along the rotor, warning the driver of the potential problem. How to Fix It
What happens when you remove the indicator stalk?
After all the screws have been removed the column shroud should split apart. You may have to wriggle the shrouds off over the various stalks and the ignition switch , so take care not to break them. In some cases the entire column will have to be lowered to remove the shrouds. You should now be able to see the indicator stalk switch.
The simple solution is to remove the bulb from the dashboard indicator warning light. This isolates the left and right indicator circuits and so prevents the cross-talk between the two sides.
How does a dashboard indicator work on a motorcycle?
In order to simplify the wiring systems on many motorcycles (otherwise known as cost saving!), many manufacturers opt to install a simple dashboard indicator signal warning lamp which flashes when either the left or right turn signals are activated.
How do you change the turn indicator on a Mercedes Benz?
Use a small screwdriver (in fact anything long and narrow object would do) to push the wire spring forward and lift it up slightly. This would release the catch. Then push the bottom of the mirror forward a little and slid the mirror upward. The mirror would slide out. It is one minute job.
What should I do if my dashboard indicator is not working?
It is also likely that your bike may fail its next MOT test if the tell-tale light is not working correctly. Hence a more permanent solution is required. The best long term solution is to slightly rewire the dashboard indicator tell-tale light by using diodes to isolate the left ad right indicator circuits.