Can a Mercedes PSE pump be reassembled?

Can a Mercedes PSE pump be reassembled?

Mercedes do not supply new impellors, The R230 PSE pump uses the same motor as other mercedes. You can get an cheep PSE on e-bay for £15.. Strip the pump and install the impellor . Reassemble in reverse order. Also I found that my motor was stuck, if after removal of the impellor check the motor is freely rotating before re-assembly.

Is the PSE pump on a 2003 SL 500?

2003 sl 500 that lost its mind. Sat for a week over Christmas and when we returned the remote key would not unlock the car. Opened the trunk, disconnected the battery and charged it up. Reconnected the battery, closed the trunk but the final latching mechanism didn’t work.

How much does it cost to remove PSE pump?

On removal before rushing to the dealer who will extract £700 + from you, Check the impeller on the motor. This is the second PSe pump I have had installed .

How do you remove a PSE from a Mercedes?

I sprayed laquer over pcb and drilled a couple of 1.5mm holes in base as it can hold water there if it should get in. Water can overflow from blocked drains or faulty rubber boot edge seal. 5. unclip vac pipes (I marked to ident. This is important) 7. using a small flat screwdriver to push detents remove base by lifting it as you go around.

Mercedes do not supply new impellors, The R230 PSE pump uses the same motor as other mercedes. You can get an cheep PSE on e-bay for £15.. Strip the pump and install the impellor . Reassemble in reverse order. Also I found that my motor was stuck, if after removal of the impellor check the motor is freely rotating before re-assembly.

2003 sl 500 that lost its mind. Sat for a week over Christmas and when we returned the remote key would not unlock the car. Opened the trunk, disconnected the battery and charged it up. Reconnected the battery, closed the trunk but the final latching mechanism didn’t work.

On removal before rushing to the dealer who will extract £700 + from you, Check the impeller on the motor. This is the second PSe pump I have had installed .

I sprayed laquer over pcb and drilled a couple of 1.5mm holes in base as it can hold water there if it should get in. Water can overflow from blocked drains or faulty rubber boot edge seal. 5. unclip vac pipes (I marked to ident. This is important) 7. using a small flat screwdriver to push detents remove base by lifting it as you go around.