How long does it take a shop to replace an alternator?
about two hours
In general, it will take about two hours for you to replace an alternator on your own, though this could vary somewhat depending on your knowledge of car mechanics. If you take your car into a shop in order to have the alternator replaced, timing may vary somewhat, and you may have to leave the car for the day.
Is it expensive to replace the alternator?
Most vehicles will fall into the $350-400 range for the total job of alternator replacement if no other parts need to be replaced. If the serpentine belt gets tacked on, add another $20 to $50 to your bill. If you decide to go with dealership parts and labor, expect the bill to climb over $500 in many cases.
How much does it cost to replace an alternator on a Mercedes Benz?
Replacing the alternator at the dealer can cost you over $1000 but if you do it yourself, you can do it for as little as $90, so keep on reading. It’s not a complicated job and we know you can do it.
Can you remove an alternator from a car?
Removing the alternator will require you to remove the drive or serpentine belt first and than the mounting bolts that attach it to the engine. Also dont forget to remove the negative cable to your battery as safety precaution.
Where is the alternator on a Mercedes Benz E CLK?
Applies to C Class , E Class, CLK Class and many other models with the V6 M112 and V8 M113 engine. Open the hood. Disconnect the NEGATIVE terminal from the battery. HINTS: Locating the battery. Depending if you have a C / E / CLK class it could be either in the engine bay compartment, under the rear seats, or in the trunk.
Where to go to replace an alternator on a Mercedes Benz?
Followup from the Pelican Staff: You can remove them and go to hardware store and match them up with a gauge. With your vehicle info handy, give The Pelican Parts parts specialists a call at 1-888-280-7799. They can figure out what part or repair kit you need.
What to do if your alternator goes out?
The first thing to check is the battery light on the instrument cluster. This light bulb is part of the alternator field circuit; if it burns out the alternator will not charge. Simply turn the key on and see if it illuminates briefly then goes off. If the light does not illuminate, you’ll need to replace it before continuing.
When to disconnect battery cable to test alternator?
Never disconnect a battery cable while engine is running to test alternator, you may cause damage to alternator or other electrical components from the surge in amperage. If your battery appears to be leaking, then your voltage regulator has probably failed.