Do you need to lubricate your Autolock hubs?
This is not to say that you will never have problems with the AutoLock Hub System but keeping them clean and lubricated is a necessary part of keeping your 4×4 system working properly. This is how I clean and lubricate my hubs.
How do you clean a guzzle Autolock hub?
In a clean workarea, remove the spring clip from the end of the hub. A small screwdriver can be used to pry one end of the spring clip out of the notch and work around the circumference until the spring is fully released. Pull the locking gear assembly from the hub cavity.
Why does vapor lock not occur in modern engines?
So this new fuel has a lower boiling point. However, vapor lock rarely occurs in a modern engine because of the use of an in-tank, electric fuel pump. This allows the pump to operate at a low point in the tank, submerged in fuel, and under a lower temperature than the older mechanical pump located in the engine compartment.
Why is my machine gun lock not working?
This is also known as the Machine Gun Locks problem. This happens because the actuators in one of the doors is defective. The plastic tappet plate component inside the actuator has broken. You can try to replace the whole actuator or replace the broken part inside it.
What to do if your vacuum door lock fails?
Diagnosing the problem begins with isolating the exact source of the issue, or the exact part of the vacuum door locking system that needs repair or attention. Every door lock in your vehicle operates with an actuator. When they fail, it can lead to problems locking one or more door.
How do you turn OFF Auto lock on a car?
Here’s how: Put the key in the ignition and turn it to on. Press the Unlock button three times. Turn the ignition off. Press the Unlock button three more times. Turn the ignition back to on. The horn should beep once. Press the Unlock button, then press Lock again.
How do I disable delayed auto locking on my GM Truck?
The entire idea is that you can turn your truck off, put your keys in your POCKET, press lock, there should be a chime that sounds when you do this. Then after you shut your drivers door you have 5 seconds to walk to any other door and open it. It will not lock until 5 seconds after all doors are closed. I use it all the time on my yukon xl.
Are there any problems with the Mercedes vacuum door lock?
Luckily, not all shops operate this way. One of the common issues that are present in a range of Mercedes vehicles is problems with the vacuum door locks. Vacuum door locks were invented decades ago, and remain a part of many vehicle designs today.