Why does the parking light stay on on my C240?
In the weeks before the battery on our C240 died, we had some odd light activity this. The front SAM control the voltage feeds to the bulb circuits, and it does not work well in low voltage situations. Is your turn indicator selected on?
Why is my turn signal not working on my Mercedes CLK?
Blown turn signal fuse or turn signal fuse keep on blowing. Short in the wires that provide 12 volts to the turn signal. You will need to locate the short and repair it. Check the wiring inside the headlight or tail light as the insulation of the wires may melt over time causing a short. We have seen this happen on several E and CLK class models.
Is there an issue with my 2002 C240?
I have a 2002 C240 and I’ve recently had an issue while driving. I’ve read similar posts to this one but someone always writes their own issues that are different from this matter.
What should I do if my turn signal light is not working?
LED lights rarely fail. The first test that you should perform is to disconnect the LED turn signal light and apply power to the LED bulb. Does the LED light turn on? If the LED doesn’t turn on, replace it. If the LED turn signal light does turn on, the LED light is not the problem.
Are there any problems with the Mercedes C240?
Check out our Mercedes-Benz C240 overview to see the most problematic years, worst problems and most recently reported complaints with the C240.
Why is my brake light not working on my Mercedes?
Yes it could be the brake light switch. It could be other problems such as low brake fluid level or failed ABS wheel speed sensor. There is no certain way to know without first doing some troubleshooting. Where is the brake light swtich located on a Mercedes-Benz? Right above the brake pedal.
Where is the brake light switch on a Mercedes W210?
In the older W210 E-Class, it is located in the back on the back of the pedal. You may need to lay on your back to access the switch. To remove the switch, press on the locking tab and then rotate it clockwise. Step 4. Install new switch Once you remove the old brake light switch, unplug the electrical wires from it.
What is the transmission code on a 2002 C240?
My C240 (US) went into limp mode, and initially stored code P0705. The check engine light would sometimes be on, sometimes off. Took it to a transmission specialist and he got the following codes: P2400 The right rear wheel rpm signal sent from the traction system via the CAN bus is implausible.