What is the crankshaft position sensor in a Mercedes Benz?
P0335 MERCEDES-BENZ Meaning The Crankshaft Position Sensor (CKP) also known as the crank position sensor is an electronic device used in an engine to record the rate at which the crankshaft is spinning. This information is used by the Electronic Control Module (ECM) to control ignition and fuel injection.
How much does it cost to diagnose p0335 Mercedes-Benz code?
The cost of diagnosing the P0335 MERCEDES-BENZ code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour. When is the P0335 MERCEDES-BENZ code detected?
What does the crankshaft position sensor ( CKP ) do?
The Crankshaft Position Sensor ( CKP) also known as the crank position sensor is an electronic device used in an engine to record the rate at which the crankshaft is spinning. This information is used by the Electronic Control Module ( ECM) to control ignition and fuel injection.
What does the code p0335 mean on a car?
This is a fairly common question among vehicle owners who own a car with an OBD-II equipped vehicle. Essentially, this code refers to an issue in the crankshaft location or its relays. The crankshaft position sensor is a stationary piece, but it works with the reluctor ring to determine positioning and voltage.
What are fault codes related to the crankshaft position sensor?
Fault codes related to the crankshaft position sensor are: P0335 Crankshaft Postion Sensor A Circuit Malfunction P0336 Crankshaft Position Sensor A Circuit Range / Performance P0337 Crankshaft Position Sensor A Circuit Low Input P0338 Cranshaft Position Sensor A Circuit High Input P0339 Crankshaft Position Sensor A Circuit Intermittent
Where is the crankshaft position sensor located on a Mercedes Benz?
If the crankshaft position sensor is not operating properly, your car will run very erratically or perhaps not at all. Replacement of the sensor is not as easy as the camshaft sensor, unfortunately. The crankshaft sensor is located on the rear of the engine up against the firewall on the bell housing.
What happens if the crank on a Mercedes Benz goes bad?
Symptoms of a defective crankshaft position sensor on a Mercedes-Benz. Failed crankshaft position sensor can also impact the idling, the acceleration, or even your transmission shifting. In some cases, it can cause your transmission to go into limp mode. You may also notice an increase in engine vibrations.