What is the error code for Mercedes W211 E 280 CDI?
Depending on the diagnostic tool that was used the error 2513 can be displayed in different formats. Fuel preparation: Fault code exhaust gas regulation too low. – Engine code: OM 642.920 Brake system: message in the display Reduced brake power! Start engine ! – Engine code: OM 642.920 Airbag: Seat belt does not roll up properly.
Where can I find the Mercedes Fault code?
Any of the scanners listed above can read and clear the Check Engine / Service Engine Fault Codes. The codes above are retrieved by plugging a diagnostic scanner into the OBD-II port located under the dash, and scanning for fault codes. Location of OBD II port used to retrieve Mercedes-Benz fault codes.
What is the fault code for an E55 AMG W211?
E55 AMG W211, E250 Sport W212, E220 Avant. W211 (and some Imps) Today my old W211 E220 CDi wont rev. above 3,000 RPM and shows code 2513-1 Check Component M55 (inlet port shutoff motor). I’m guessing the motor may be bunged up and stuck/sticking. Anyone any experience of this and am I right in the below sequence? 1. Engine Cover 2.
Any of the scanners listed above can read and clear the Check Engine / Service Engine Fault Codes. The codes above are retrieved by plugging a diagnostic scanner into the OBD-II port located under the dash, and scanning for fault codes. Location of OBD II port used to retrieve Mercedes-Benz fault codes.
Why does my W211 E220 CDI not Rev?
Today my old W211 E220 CDi wont rev. above 3,000 RPM and shows code 2513-1 Check Component M55 (inlet port shutoff motor). I’m guessing the motor may be bunged up and stuck/sticking. Anyone any experience of this and am I right in the below sequence? 1. Engine Cover 2. Throttle Actuator 3. Charge Manifold 4.
E55 AMG W211, E250 Sport W212, E220 Avant. W211 (and some Imps) Today my old W211 E220 CDi wont rev. above 3,000 RPM and shows code 2513-1 Check Component M55 (inlet port shutoff motor). I’m guessing the motor may be bunged up and stuck/sticking. Anyone any experience of this and am I right in the below sequence? 1. Engine Cover 2.
How to replace the shut off motor on a Mercedes?
1 screw, 1 bolt, image (h). At the bracket to the front of the turbo remove the bolt into the turbo, the bolt down into the shut off motor, and the 2 bolts into the head. Remove bracket, 4 bolts total, image (j). 2 bolts, image (b). The turbo should allow enough play to remove the intercooler pipe.