How does small engine choke work?
By restricting the flow of air into the throat of the carburetor, the choke valve reduces the pressure inside the throat, which causes a proportionally greater amount of fuel to be pushed from the main jet into the combustion chamber during cold-running operation.
How does a choke work on a 2 stroke engine?
A choke restricts the flow of air at the entrance of the carburetor. This creates a stronger vacuum which draws in less air but more gasoline to create a “rich” fuel which is easier to ignite when the engine is cold.
Where is the choke located on a motorcycle?
If you aren’t sure, you can tell by looking for a choke control. It is normally located on the left handlebar, above the horn. Carbureted motorcycles have a choke, but fuel-injected bikes do not. Sit on your motorcycle seat when starting it.
Do 2 stroke engines have a choke?
Most two stroke engines will have a choke setting that can be manually adjusted for the current atmospheric settings. When a two stroke starts up, the choke cuts off a large portion of the air supply, causing more vacuum, so more fuel is burned at the start.
How to install a choke control on a carburetor?
Insert the cable bowden wire into the choke control (front or reverse pull). Then place choke cable under the cable clamp. 3. Position the choke control so it bottoms, then pull it back approximately 1/16″ (1.5 mm). Make sure that the carburetor choke is fully opened before tightening cable clamp. 4.
Where is the choke and throttle cable located?
Insert the control cable bowden wire in the proper hole of the engine control lever, which is located on the side of the carburetor air intake elbow.
What is the firing order of a Chevy Turbo Air 6 engine?
The #1 cylinder is at the right rear with cylinders 1, 3, and 5 on the right, while #2 is the left rear with cylinders 2, 4, and 6 on the left. The firing order is: 1-4-5-2-3-6. The crankcase is cast as two box-section halves. The assembled crankcase provides for four main bearings.
How many cylinders are in a Chevy Turbo Air 6 engine?
The engine’s major components include an aluminum crankcase, two three-cylinder aluminum cylinder heads with integral intake manifolds, and six individual iron cylinder barrels. The #1 cylinder is at the right rear with cylinders 1, 3, and 5 on the right, while #2 is the left rear with cylinders 2, 4, and 6 on the left.