How to diagnose a Mercedes-Benz turbine sensor circuit?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. The cost of diagnosing the P0718 MERCEDES-BENZ code is 1.0 hour of labor.
Why do Mercedes W115s have different gear ratios?
This is because the yoke/flange are of a different size. You could also swap out the cardanshaft/driveshaft to one with the right size yoke, if you for example are building a tuned w115 and need something beefier than the stock flexdisc
Can you change the differential on a Mercedes W123?
Changing differential w123: http://mbturbo.com/how-to-change-final-drive-w123/ The differential is the same on a w1114, w115, w116, w123 and w126 (first generation) a first generation w126 diff will fit on a w114,but wont fit on a 1986 w126.
Which is a better gear ratio 2.24 or 1.24?
regarding ratios, you are correct, the ratio is the amount of revs the driveshaft turns the ingoing axle to the diff, for the wheels to turn one revolution. a 2.24 will thus be a lot faster at the same enginespeed and same gear in the gearbox.
What is the fault code for a D2B ring?
N1141 MCS fault code: Set-actual configuration of D2B ring differs from actual. N1241 CD fault, CD can not be read. 9260 SRS: resistance in drivers airbag too high. Replace Wiring. Please post a link to this string of posts in the Useful W163 Documents and the DIY Stickys at the top of this forum. done. good stuff.. Anyone know anything about it?
What causes p0715 Mercedes-Benz transmission speed sensor to malfunction?
P0715 MERCEDES-BENZ Possible Causes 1 Faulty Transmission Speed Sensor 2 Transmission Speed Sensor harness is open or shorted 3 Transmission Speed Sensor circuit poor electrical connection More
How many control units does a Mercedes Benz have?
There are also codes for other control units such as transmission, ABS, SRS, ESP, 4ETS, airbag, A/C. Mercedes-Benz can have up to 47 control units. You can NOT diagnose them with a simple OBD-2 scanner. To read these systems and their fault codes or erase them from your Mercedes-Benz you need more advanced OBD-II scanners.
Where are the fault codes on a Mercedes Benz?
Cut off line to Pin 11 (BNYE), Pin 12 (BU) and line to Pin 4 (YE) approx. 160mm after the connector (14-pin) of the frame floor system (FFS) wiring harness to the steering column tube (N80) and unpin from steering column tube module connector. Slide back the flexible cable set jacket and fix in place for this purpose.