What causes ABS warning light on Mercedes W204?
This fault can cause the engine to run rough and idle poorly. Common ABS pump and module failure for C-Class W204 range will cause the ABS warning light to illuminate and store fault codes for ‘internal fault’
Why is my Mercedes Benz ESP light not working?
Low Battery Voltage – If you have an old Mercedes-Benz battery which is not supplying the needed voltage you can cause ESP malfunctions and a variety of other problems such as ABS and ETS warnings. This is tricky because the battery may start the car just fine, but it doesn’t maintain the requried voltage while the car is running.
Why is the radio not working on my Mercedes Benz?
Is the radio on your Mercedes-Benz not working? Some common problems with the Mercedes-Benz COMAND system include issues such as: Radio panel doesn’t turn on. (Hint: Check fuses.) The fist thing you should try is to do a soft reset of the COMAND unit.
Why does my Mercedes Benz C300 not start?
I’m having the same issue with my Mercedes Benz C300 2008-the first time I was stuck on the 12th floor and no tow truck would fit in the parking garage-we ended up rolling it down the 12 floors. The battery was so dead that the wheel wouldn’t turn, the ligts went on and the dash lit up but the car just wouldn’t start.
What causes ESP light to illuminate on Mercedes E-class?
This is a common problem with the E-Class. In some cases, the gear shifter can cause the ESP light to illuminate if liquid gets spilled on the shifter. Mercedes C-Class W203 W204 ESP light -ESP light on a C-Class is typically caused by a defective brake light switch or low battery voltage.
Are there any problems with the Mercedes W204?
But despite the problem I don’t regret getting a W204 one bit. Consumers Reports said the new C-class is “average” in terms of reliability which is a significant improvement over Mercedes in the last 7 or 8 years. Read all three pages & most of that stuff was real tick tacky BS IMO.
Is the radio on your Mercedes-Benz not working? Some common problems with the Mercedes-Benz COMAND system include issues such as: Radio panel doesn’t turn on. (Hint: Check fuses.) The fist thing you should try is to do a soft reset of the COMAND unit.
Why is my gear selector not working on my Mercedes C-class?
The C-Class W203 and pre-facelift W204 has a common fault with the automatic gear selector module / gear lever. This gear selector will cause problems preventing selection of any forward or reverse gears until the ignition is cycled. The gear selector position will not be recognised on the gear display or will show incorrectly.
What causes a back light to go out on a Mercedes?
Complete loss of back lighting. We are currently rebuilding customers own units with an unlimited mile warranty, this is a very common failure for the Mercedes S & E Class instrument cluster. This is a common problem causing the “F” light to appear on the dash and the gears feel as though they are banging in to place…
What do the lights on the Mercedes dashboard mean?
Modern Mercedes-Benz cars are filled with lots of sensors that monitor how each system in the car is behaving. The lights on the dashboard display what systems are in use and they also highlight when one of those systems is not working as it should. But what do all those different symbols mean?
How to reset the Mercedes Benz ESP warning light?
Replacing the ABS sensor is easy, you can learn how to replace ABS sensor here. Note that once you will replace the ABS sensor and will still have the ESP warning light on. You will need to follow the procedures below to reset the light.
What happens if you drive a Mercedes Benz in first gear?
If you drive the car on first gear for too long with doing any change to another gear, or for example, getting to a hill on first gear at a constant speed, it gets over heated and needs to cool down inmediatly or as some of you have experienced, need to turn of the car, wait some minutes and turn on again and keep driving normally.
When does the F Go Away on a Mercedes?
After clearing codes, “F” goes away. You can see 1st, 2nd , 3rd (basically all the gears) but only when car is stationary. As soon as you try to drive it, it goes back into limp mode and the big fat “F” comes right back on.
What should the amperage reading be on a Mercedes medic?
As you remove each fuse you should check the amperage reading on the multimeter. If the multimeter reading is still high, reinstall the fuse and go to the next fuse. Continue removing and reinstalling all the fuses one at a time, until you pull one that makes the multimeter reading drop to below 0.5 A.