What to do if your 6 CD changer wont work?
VIN Locked Stereo. 6 CD changer jammed, will not play CD’s, will not accept or eject CD’s, repair rate $295. A “Reset” may bring this changer back to working. Disconnect negative terminal from battery, (most cases, negative terminal is easiest, 10mm), remove for 5 minutes and reconnect.
How can I repair my GMC CD player?
A “Reset” may bring this changer back to working. Disconnect negative terminal from battery, (most cases, negative terminal is easiest, 10mm), remove for 5 minutes and reconnect. This may bring the changer back to working, otherwise this is a repair issue. See Removal Guides and link to Shipping page before sending for repair.
What should I use to repair my CD player?
Remove dust with canned air or a soft brush. If needed, use a foam swab or camera-lens tissue (not eyeglass tissue) dampened with lens fluid. Open the housing by removing the screws on the outside of the housing and remove anything blocking the tray. Press the open-close control to extend tray, and unplug the unit.
Why does my CD changer not accept cartridge?
I took out my cartridge to change cds and tried to put it back in and now the changer does not want to accept the cartridge. When you try to push it in and pushed back out. If you hold it in and turn on the radio it will load the 1st disc but when you change discs it ejects the whole cartridge.
How to fix a stuck CD tray on a CD changer?
How to fix a stuck cd tray/drawer on a cd changer, replace belts and disassemble. Remember to ALWAYS keep your equipment UNPLUGGED while repairing and proceed with caution. Loading…
What causes a CD changer to get dirty?
Over time a cd changer can stick from either sitting or too much usage. The grease goes dry out and becomes dirty which is turn ruins it’s lubricating qualities. Other times the laser can become dirty or the components just wear out all together.
Can a CD changer be removed from the car?
Not all cd changers use a cartridge cd dispenser either. The cd changer unit does need to be removed from the vehicle when doing this repair and it’s also good practice to wear a ground strap so you don’t risk damaging any internal electrical components. This particular tutorial was done on a 1997 BMW 540i.