Is there an ASR problem on my S500?

All readings ok: 120 ohms across the bus and continuity to all modules on the bus. After re installing the modules, which had all cooled down, the car was started, NO ASR lamp. Ran perfectly. Drove it for about 20 minutes, parked it in the sun (yesterday in SD, it was 95degs).

What are the problems with a Mercedes Benz?

Top 5 Mercedes-Benz no start problems 1 Engine Click, No Start 2 Engine Dies Right After It Starts 3 Car turns over, but it won’t start 4 The car makes a clicking noise but won’t start. Hint: Starter Problem or Low Battery 5 Key will not turn the ignition More …

What to do if your Mercedes SL500 has a bad ETA?

His web site contains a wealth of Mercedes repair information including ETA repair employing a video “primer” course on the art of ETA repair. This link shows how to detect a going/gone bad ETA and how to inspect the ETA wiring harness to confirm that it’s bad. This video is for a ’95 SL500.

What happens when Mercedes Benz air suspension stops working?

When they stop working the air suspension control unit may no longer be able to recognize the height of the car. Your Mercedes-Benz will greet you with a warning message on the dash related to the airmatic failure. The car height may be correct and the car still rides fine, it’s just that the computer doesn’t know that.

Where is the ASR light located on an ABS?

But now the ASR light is on. So to kill that, insulate pin 29 on connector 1 of the ABS/ASR [N30/1] module by using a strong but thin tape. The MIL signal comes from this module and lights the ASR lamp located in the IC.

How does traction control work in an ABS car?

In fact, traction control uses the same components as ABS: wheel speed sensors that monitor the speed of rotation of the front or all four wheels; a hydraulic modulator that pumps the brakes, and;

Why is traction control an active safety feature?

Traction control is an active vehicle safety feature designed to help vehicles make effective use of all the traction available on the road when accelerating on low-friction road surfaces. When a vehicle without traction control attempts to accelerate on a slippery surface like ice, snow, or loose gravel, the wheels are liable to slip.

Is there a problem with the ASR on a Mercedes?

I guess that if you own a Mercedes, you will at some time get that problem! The ASR problem seems to occur in two distinct ways: It can occur while driving and gives the driver quite a start! The car goes into the LH mode (will be described later) and the accelerator pedal does not respond as before. It’s quite a ‘trip’ to drive the car.

What can I do about my 1995 SL500?

This video is for a ’95 SL500. Victor will repair or rewire the ETA complete with harness for a very reasonable price if you want. He also can repair / rebuild most other parts such as the engine wiring harness, closing assist pump and most other systems in the car.

What was the problem with the ASR on my 1992 500SL?

I started having a problem with the ASR system on a 1992 500SL. I was driving on the highway when the ASR sensor light came on and the car defaulted to a “limp home mode”: The engine output power was reduced and I was able to make almost home; after stopping at a red light the battery light came on and the car completely stalled.

What causes the ASR light to come on on a Mercedes 500SL?

Everything pointed to the Electronic Accelerator Actuator (that checked out okay as well). After discussing the past few months with the car, we established that my problem was moisture in the R25 sensor (throttle positioning sensor) causing the ASR light to come on and the engine to go into the LH mode.

How to disable the ASR system Mercedes 500SEC?

You asked for how to disable the ASR-system: unplug the round connector plug in the side off the ASR-pump and the automatic failure check will force the system to go off. The same happens if any of the plugs belonging to ABS or ASR systems are off.

What does ABS Bas, ASR, ABS lights mean?

What ASR, BAS, ABS lights mean. Common problems and possible solutions. What do ABS BAS ASR lights mean? If any of these lights turns on and stay ON once you start to drive the car it means there is a problem with one of the following systems or related sensors. Step 1: Ensure that the main battery on your Mercedes-Benz is holding a proper charge.

What does ASR stand for in Mercedes shop Forum?

Mercedes Shop Forum is now PeachParts Mercedes Shop Forum. ASR stands for “Acceleration Slip Regulation” and it is Mercedes way of guarantying that the wheels have equal traction when you need to accelerate quickly.

What is code 30 for ABS W ASR?

ABS w/ ASR Module: Code 30 – – CAN bus to EA/CC/ISC faulty. LH-SFI Module: No codes. DI Modules: No codes. I removed all of the modules in the F23 box, removed the box frame itself, and inspected all of the wiring to the connectors especially to slots 4/5 (ABS w/ ASR) and 6/7 (EA). All wiring was ‘solid’. Using an ohmmeter, the CAN bus was checked.

What does ABS Bas ASR light on Mercedes mean?

What do ABS BAS ASR lights mean? If any of these lights turns on and stay ON once you start to drive the car it means there is a problem with one of the following systems or related sensors. Step 1: Ensure that the main battery on your Mercedes-Benz is holding a proper charge. Mercedes-Benz cars are very sensitive to low voltage.

Why does the ASR light go off when I stop the car?

2) The ASR light comes on, tachometer indicates 1000 rpm but can drive the car even though it’s in the Limp-Home (L-H) mode. 3) If the ASR is on, drive for 5 minutes or so, stop, re-cycling the ignition and the ASR light will go off and STAY off until I stop the car and let the heat build up in the engine compartment.

Why does my Mercedes Benz make a clicking sound?

The clicking sound and the rest of the symptoms may be attributed to a broken stepper motor lever or the footwell damper linkage. This is a common problem in MB C230, C240, C320, CLK320, CLK350, CLK500 but this problem can affect other Mercedes-Benz models such as E, S, CLS, GL, ML Class.

What to do when Your Fuse Box is making a clicking noise?

Locate the problem relay. Open the lid on your fuse box and take a look at the relays — the small black cubes scattered around the fuse box. Hold the handle of a screwdriver to your ear and touch the top of each relay with the tip of the screwdriver.

What does a relay do in a fuse box?

Relays control a high-current circuit using low current. It makes it possible to control things like the headlights and the fuel pump without running high-amperage current into the passenger compartment. Try swapping the relay. Remove the relay from the fuse box — It pulls straight out.

When to turn off the ASR on a car?

ASR is on and activated at each ignition cycle / every time the car is started and you cannot permanently switch it off. You should only switch ASR off if: Your car is stuck in snow or mud. ASR will prevent wheel slip which on certain conditions can hinder you.

What to do if Bas ASR light is still on?

If you are still having BAS/ASR light problem, it may be time to have an auto mechanic or a Mercedes-Benz dealer in your area perform a diagnostic. If you want to figure out the BAS/ASR problem on your own, you will need to get a hold of an advanced diagnostic scanner to do a complete system scan and read the fault codes.

Where is the ASR off button on a car?

ASR Off Button ASR is featured on certain car makes and models such as Fiat 500, Skoda, Mercedes, VW, Audi, Isuzu, Alpha Romeo. You may notice on your dashboard or center console an ‘ASR OFF’ button. Press this button to deactivate ASR.

Why is my air conditioning not working on my Mercedes S500?

What are common reasons my Mercedes-Benz S500 has air conditioning problems? While there are a variety of reasons your Mercedes-Benz S500 air conditioning won’t work, the most common 3 are a refrigerant leak, an electrical climate control issue, or a problem with the air conditioning compressor.

What’s the problem with my Mercedes W140 S500?

Hi There,I have a Mercedes 1995 W140 S500. Here’s the problem. When the ASR light comes on the car stalls and it seems as if the engine has cut out. When I depress the accelerator the engine comes back to life and the car starts to move very slowly.

When does the ASR light come on in my car?

Was able to find a compatible EA/CC/ISC [N4/3] module to test in my car. Well, it worked for a while! Same thing after 6 trips or so: If the car is stopped after high speed driving and then into stop-go traffic for 10 mins or so, ASR light comes on. The engine heat builds to 100C or so when the key is switched on.

What’s the ASR code on a 1995 SL500?

My recent purchase of a 1995 SL500 has gotten the ASR bug. It only has 58K and is in EXCELLENT condition. On the ASR it has code 030 (no reception from EA/CC/ISC N4/1 or fault in EA/CC/ISC).

Where is the SRS on a 1994 SL500?

For your 1994 SL500, the diagnostic setup is from a 16-pin plug. For your model, the Supplemental Restraint System (SRS) is read from Pin #6. In your SL500, the SRS System is one (of only two systems) that does NOT provide a DTC readout of “NO FAULT FOUND”. Make sure you READ ALL SYSTEMS’ CODES, RECORD the Codes, then RESET all CODES.

Is there a problem with my Mercedes SL 500?

It only has 58K and is in EXCELLENT condition. On the ASR it has code 030 (no reception from EA/CC/ISC N4/1 or fault in EA/CC/ISC). My friend thinks it has a problem with the ASR computer….I was just wanting to get some second opinions from people who know Mercedes, because this ASR computer is expensive.

Navigation