How to change lock modes on Mercedes SLK?
Check PSE for corrosion or water ingress. Plenty of posts on this in the stickies. There are two central lock ing modes – driver door only and global (all doors). See the drivers manual. You can change between modes with the remote (when working) by holding the lock button for 5 seconds till the LED on the fob flashes.
What are the common problems with Mercedes key fobs?
Common Mercedes Key Fob Problems Go to top 1 Mercedes key fob not working after battery change 2 Mercedes remote doesn’t work anymore 3 Keyless remote doesn’t lock/unlock the car 4 Mercedes key fob won’t unlock doors 5 Panic button doesn’t work 6 Trunk unlock doesn’t work
Why does my Mercedes E320 alarm keep going off?
I had the same problem on my 01 E320 which would start and run even at 10 volts (bad battery). What I did was to check the battery after driving the car some distance. You should get I think at least 12.5 volts at that time. Then check it in about 6 hours and if not driven again after 12 hours. You should get very little drop.
Where are the fuse boxes in a Mercedes Benz SLK?
There are 3 fuse boxes in your slk. One in the engine bay. One in the trunk. One on the driver side when you open the door and look at the side where your headlight switch is. You need a coin to twist 90% the two 1 inch wide plastic tabs to open the side panel. Youll find the last fuse box inside.
Is there a problem with my 2001 SLK 320?
My 2001 SLK 320 just developed the same problem, and the dealer proposed a $1000 PSE replacement. After reading this and another forum, I went out and replaced the $1 fuse and everything is working perfectly.
What happens when you unlock a 2001 SLK 230?
When I tried to unlock my 2001 SLK 230 this morning, my indicators were flashing when I pushed the unlock button on my remote control, but nothing happend… :-\ No sound at all.. just the flashing lights.
My 2001 SLK 320 just developed the same problem, and the dealer proposed a $1000 PSE replacement. After reading this and another forum, I went out and replaced the $1 fuse and everything is working perfectly.
When I tried to unlock my 2001 SLK 230 this morning, my indicators were flashing when I pushed the unlock button on my remote control, but nothing happend… :-\\ No sound at all.. just the flashing lights.
Common Mercedes Key Fob Problems Go to top 1 Mercedes key fob not working after battery change 2 Mercedes remote doesn’t work anymore 3 Keyless remote doesn’t lock/unlock the car 4 Mercedes key fob won’t unlock doors 5 Panic button doesn’t work 6 Trunk unlock doesn’t work
How do I Sync my Mercedes fob to my car?
To synchronize a Mercedes-Benz key to your car all you need to do is insert the key into the ignition for a few seconds. This works in most cases but every now and then you may need to follow further instructions to synchronize your Mercedes key fob remote with your car.
Why does my Remote key not unlock the door?
When the physical key can lock or unlock the door, be sure that the mechanism of the locks is fine. There could be an electrical issue that prevents the fob from connecting to the door’s receiver sensor. These are mostly the reasons and troubleshooting options when a remote key won’t unlock car door.
Where is the key for unlocking the car door?
Vehicles have a physical key for locking and unlocking the door. If you close and open your car door with the smart fob, this key is likely to be hidden inside the fob. There should be a release button or catch in the remote, pressing which will pop out the spare key. But some vehicles may not have a visible keyhole. Don’t worry.
Check PSE for corrosion or water ingress. Plenty of posts on this in the stickies. There are two central lock ing modes – driver door only and global (all doors). See the drivers manual. You can change between modes with the remote (when working) by holding the lock button for 5 seconds till the LED on the fob flashes.
When the physical key can lock or unlock the door, be sure that the mechanism of the locks is fine. There could be an electrical issue that prevents the fob from connecting to the door’s receiver sensor. These are mostly the reasons and troubleshooting options when a remote key won’t unlock car door.
What should I do if my key fob is not working?
Remove the metal key from the keyfob and use it to manually unlock the doors. Next, you need to check the fuse for the central locking circuit. Not only that but also look at the fuse for the Antenna Module and AAM.
Where are the central locking pipes on a Mercedes SLK?
Suck locks, blow unlocks. The three yellow pipes are connected to: The drivers door only, the passenger door and boot lock and finally the fuel filler flap and cubby box lid lock. You can manually test the function of the actuators on these components by sucking and blowing on the individual pipe ends.
Why is my Mercedes R170 central locking not working?
Often if you listen carefully at the latch section on the door edge while the pump is running, any hissing is a sure indication that the pipe connector has broken inside the door and will need attention. To gain access to the door lock actuator and its yellow pipework you will have to remove the door card.
How to fix error in power door locks or central lock?
How to fix error in power door locks or central lock system Toyota Corolla. Years 1999 to 2007. – YouTube How to fix error in power door locks or central lock system Toyota Corolla. Years 1999 to 2007. If playback doesn’t begin shortly, try restarting your device.
Are there any problems with Mercedes SLK central locking?
Central locking problems in the R170 series of Mercedes Benz SLK are quite common. The issues are usually centred around the failure of the PSE (Pneumatic System Equipment) pump unit or its connecting air pipework. The pneumatic door lock actuators are simple by design and as a result are found reliable, even in older cars.
Often if you listen carefully at the latch section on the door edge while the pump is running, any hissing is a sure indication that the pipe connector has broken inside the door and will need attention. To gain access to the door lock actuator and its yellow pipework you will have to remove the door card.
What causes the PSE pump to run in a Mercedes SLK?
Actuating a fully functioning key fob will cause the PSE pump to run for a period, as will unlocking the drivers door, opening the drivers or passenger door, unlocking the boot or operating the dash ‘door lock’ switch. Listen out for the pump motor running in the area of the boot floor just below the rear of the fuel filler.
Where are the three yellow pipes on a Mercedes SLK?
The three yellow pipes are connected to: The drivers door only, the passenger door and boot lock and finally the fuel filler flap and cubby box lid lock. You can manually test the function of the actuators on these components by sucking and blowing on the individual pipe ends. This takes a bit of ‘puff’ but it can be done.
What to do if your Mercedes FOB is not working?
Insert the key and turn it to the “ON” position, then press and release the lock button on the key. Press and hold the remote’s unlock button. In 1-2 seconds, press the remote’s lock button five times in a row while holding the unlock button. Good Luck.
Why is my Mercedes SLK door lock not working?
The issues are usually centred around the failure of the PSE (Pneumatic System Equipment) pump unit or its connecting air pipework. The pneumatic door lock actuators are simple by design and as a result are found reliable, even in older cars.
How to central lock a Mercedes SLK R170?
Operate the lock from the dash or key and identify the leaks in the area where the pipe joins to the grey push on connector. Usually once you touch this area the pipe breaks off completely! The connector can be levered from the actuator with a screwdriver, it is a snap fit.