Do DVD players have a fuse?
The fuse is located on the right side (facing the front) midway along the edge of the circuit board. It is located under the DVD player. Be sure to replace with a “slow-blow” type fuse.
Why is my Blu-ray player not turning on?
Check to make sure that the power cord is connected properly to both the Blu-ray player and to a working power outlet. Make sure to wait at least ten seconds after plugging in the Blu-ray player before pressing the power button. You could also try plugging the cord into a different wall outlet.
Why do I have no power on my DVD drive?
For internal drives, check computer cooling fans, filters, and ventilation. DVD drives can sometimes be the most susceptible to heat problems. 1) The DVD Drive Has No Power. The most common cause of this DVD problem is an issue with the power connection or power protection. This is particularly true with external drives.
What should I do if my DVD player won’t play?
If the DVD drive never responds, then it may be a failure that requires repair of replacement. If the DVD drive seems to have power, opens and closes, and seems to be working with Windows but still won’t play, then (as described above) the first thing to try is another DVD, and perhaps try the non-working DVD in a different drive.
Why does my Toshiba DVD player not turn on?
Thanks for your input,I decided to pull the cover off, and just behind the power button,there is a circuit board with either 3 transistors or some kind of capacitors that are very close together, which looked like they may have fried, there is some crusty brown stuff that hardened between all 3. Again thank you…. Was this answer helpful?
Why does my Dell DVD player not play?
Because I’ve been in warranty, Dell has sent replacements at least three times now. Maybe other folks will reply with a better tech answer, but if they don’t, use your warranty and ask Dell to send you a replacement. 10-14-2012 05:04 PM Re: Why won’t some DVDs play in my computer’s DVD drive?
What to do if your DVD player has no power?
As usual, when an equipment is no power the first thing to check is the power supply section. The best point to test will be the output points or the connector points. When I checked on the output points I found 5 volt and 12 volt were present. This proved that the power supply was working and the fault could be in the mainboard.
How can I tell if my maps DVD player has no power?
This MAPS DVD player came in for repair with the complaint of no power. As usual, when an equipment is no power the first thing to check is the power supply section. The best point to test will be the output points or the connector points. When I checked on the output points I found 5 volt and 12 volt were present.
Why does my DVD player not play back a DVD?
You may have to download the file to a DVD+R disc because DVD-R discs don’t play on many players. It might also be the hardware DVD player issue. Your hardware DVD player might need to get updated or optimized so as to recognize and play back burned DVD discs.
Can a DVD player play on a TV?
In most cases, individuals tend to assume that the DVD format that they are using is automatically compatible with their players. That is not the case, you must ensure that the DVD disc that you are using is compatible with the DVD player and it is not faulty. To burn videos to playback on DVD players and TV, you can’t miss Aimersoft DVD Maker.