What does run flat indicator inoperative mean on Mercedes Benz?
Pulled wheel hub to chassis nice and tight and vibration gone. steering wheel wonky now. so heading off to get 4 wheel alignment reset tomorrow. only driven 50 miles since arms been done. but yesterday afternoon “Run flat indicator inoperative” refer to manual popped up and showing the vehicle with squiggly lines under it on display.
How is message run flat indicator inoperative on SLK 250?
Re: Message – Run flat indicator inoperative on Slk 250… As you may be aware of, Mercedes does not approve of “unauthorized” repairs. Having said that, most of therse systems function as follows: 1) 4 wheel sensors ( with internal “batteries” ) send signals to an on-board pick up that relays the signals to the dashboard indicator light.
Are there any problems with the Mercedes GLK 250 BlueTEC?
If anything you may want to remove the dosing valve (adblue injector) that is clamped to the exhaust and make sure the injector is not leaking. The biggest problem with adblue is the crystallization , it clogs and also makes things stick open. If not that then your module that was bad may have been injecting adblue excessively.
What is the temperature sensor code on a GLK 250?
The only other code in the car is a 205C16 (The temperature sensor “Adblue tank” has a short circuit to ground) It is current and I can’t erase it. What could be causing it to dump that much DEF?
Is the run flat indicator on my Merc e200 inoperative?
I have the following message “ESP inoperative” and “Run flat indicator inoperative” on my Merc E200 Kompressor manufacture date 2009 recently. Can anyone share on what is wrong. Could it be the ESP sensor is faulty. Anyone knows how much does it cost to replace it and where can I get this done as a reasonable price?. Thanks.
What is the BlueTec code on a 2013 Mercedes GLK 250?
2013 Mercedes GLK 250 bluetec has code P24C600 (the temperature sensor in the soot particulate sensor has an electrical fault). This is keeping the check engine light on.
The only other code in the car is a 205C16 (The temperature sensor “Adblue tank” has a short circuit to ground) It is current and I can’t erase it. What could be causing it to dump that much DEF?
What causes a Mercedes Benz to run flat?
Check your speed sensor too, because that ‘run flat inoperative’ may be caused by inoperative speed sensor (IF your run flat system is speed sensor, not pressure sensor based? VIN will tell… only I cannot remember which code was which :Oops. And speed sensor could affect other mentioned faults too.