What is the switch on the trunk open?
The Trunk Open’s actual micro-switch (arrow) is either open or makes contact pending the lever’s position. The Trunk Lock Switch is part of the latch. (Please see the separate article on latch removal.) The micro-switch (arrow) unclips from the latch assembly should it need to be replaced.
Where can I get roof switch for my SLK?
SLK owners who possess soldering skills can likely find comparable micro-switches for a few bucks at an electronic parts supplier, then add the necessary pigtails themselves. Roof Closed Limit S69/1 Right Upper Windshield 170-820-07-10-MBZ $75.00
Where are the switches on the R170 vario roof?
Other articles show how to operate the roof manually when necessary. Here, we reveal the locations of the nine switches in the R170’s Vario roof system. The actual switches are often part of larger housing assemblies. This permits the switches to be replaced independently, avoiding the higher cost of replacing the whole shebang.
What is trunk open switch on Mercedes SLK 230?
The Trunk Open switch has a spring-actuated lever (arrow) that senses trunk position. Its housing can be opened with a flat blade screwdriver. The Trunk Open’s actual micro-switch (arrow) is either open or makes contact pending the lever’s position. The Trunk Lock Switch is part of the latch.
Where is the closed switch on a car?
A Trunk Closed switch (arrow) is located on either side of the trunk on the wheel well, behind the side paneling. It senses if the trunk lid is latched. The Trunk Closed switch bracket/cable release mechanism comes apart by using a T27 Torx bit.
Where are the roof closed limit switches located?
The Roof Closed Limit Switches are located in the windshield frame (arrow), one on each side. The upper windshield panel must be removed to access the Roof Closed Limit Switches. (Please refer to that article for details.) Before removing the switch, mark its location so that it can be re-installed to catch the roof latches properly.
Where is the trunk open limit switch located?
The Trunk Open Limit Switch (arrow) is in the right rear corner, mounted to the bracket over the hydraulic pump. Unbolting the bracket with a T27 Torx bit allows the switch (arrow) to be slid out of its mounting slots.
A Trunk Closed switch (arrow) is located on either side of the trunk on the wheel well, behind the side paneling. It senses if the trunk lid is latched. The Trunk Closed switch bracket/cable release mechanism comes apart by using a T27 Torx bit.
Where is the micro switch on a Mercedes SLK?
The micro-switch can be unclipped from the housing (#170-790-02-77-MBZ) and replaced separately (see part numbers above). The Open/Lowered Limit Switch (arrow) is located under the plastic B-pillar trim piece on the right side.
How to remove roof switch from Mercedes SLK 230 Vario?
It senses if the trunk lid is latched. The Trunk Closed switch bracket/cable release mechanism comes apart by using a T27 Torx bit. A small flat blade screwdriver can then be used to unclip the switch (arrow) from the rest of the assembly.
Why is my switch not in Trunk Mode?
05-24-2006 02:55 PM When trying to execute the above command am getting the following error. Command rejected: An interface whose trunk encapsulation is “Auto” can not be configured to “trunk” mode. 05-24-2006 03:30 PM 05-24-2006 03:30 PM
How to enable a port trunk group in hp switch?
HP Switch(config)# no trunk c4-c5 Enabling a dynamic LACP trunk group In the default port configuration, all ports on the switch are set to disabled. To enable the switch to automatically form a trunk group that is dynamic on both ends of the link, the ports on one end of a set of links must be LACP Active.
The Trunk Open’s actual micro-switch (arrow) is either open or makes contact pending the lever’s position. The Trunk Lock Switch is part of the latch. (Please see the separate article on latch removal.) The micro-switch (arrow) unclips from the latch assembly should it need to be replaced.
The Trunk Open switch has a spring-actuated lever (arrow) that senses trunk position. Its housing can be opened with a flat blade screwdriver. The Trunk Open’s actual micro-switch (arrow) is either open or makes contact pending the lever’s position. The Trunk Lock Switch is part of the latch.
Why is my trunk lock not working properly?
One of the major issues that can occur with this device is that the motor will work, but the locking mechanism does not. A locking mechanism has multiple components inside the actuator; one of which is a linkage system that manually moves the lock to the open position when the actuator is activated.