What kind of fault is on Vito 111cdi?
Travelling at speed on the motorway, van went into ‘limp’ mode and engine fault light came on. An investment in the excellent ELM 327 bluetoth code reader and equally good free ‘Torque’ app showed the fault to be P0404 – Exhaust Gas Recirculation Circuit Range/Performance.
What is the diagnostic code for Mercedes Vito 2006?
Diagnostic code P2359 any idear of fault Mercedes Vito 2006 111cdi – Answered by a verified Mercedes Mechanic We use cookies to give you the best possible experience on our website. By continuing to use this site you consent to the use of cookies on your device as described in our cookie policyunless you have disabled them.
What causes a fault in a Mercedes Vito?
Most likely there is a leak in the charge pressure hoses or intercooler. Also there is a possibility of turbocharger efficiency control actuator sticking. With Star Diagnosis computer it would be possible to read out exactly at which conditions the fault occurred, and actuate the boost control.
What are the fault codes for a Mercedes Benz?
P0216 Injection Timing Control Circuit Malfunction P0217 Engine Overtemp Condition P0218 Transmission Over Temperature Condition P0219 Engine Overspeed Condition P0220 Throttle/Petal Position Sensor/Switch B Circuit Malfunction
Travelling at speed on the motorway, van went into ‘limp’ mode and engine fault light came on. An investment in the excellent ELM 327 bluetoth code reader and equally good free ‘Torque’ app showed the fault to be P0404 – Exhaust Gas Recirculation Circuit Range/Performance.
Why does my Vito CDI 110 2000 shut off?
Hi My Vito CDI 110 2000 has Shut off Fault Code, Boost Pressure Code. 7.5a ECU Fuse causes grey smoke rough running when inserted. Merc Star Can not communicate with the CDI. Van starts and runs ok without the 7.5a fuse but in limp mode. Help.
Are there any problems with the Mercedes Vito ECU?
Similar problem with the bas brake assist, had it diagnosed, replaced g force sensor and brake sensor, as that what fault codes came up, reset it, but light is back on!! Spent allot of money on original parts, and it is still the same, could it be the ECU it’s self?
What are the warning lights on a Mercedes Vito?
On start up I had two warning lights, glowplug light on (always) and the EDC light on (always). The glow plugs have current for the heat up process and then there is no currnet to them after a couple of seconds so performing properly but the light remains on.