Does a SRS module have to be programmed?
When you buy a new control module, most of the time it will need to be additionally programmed /coded to the car to inlcude the VIN and the configuration. The most common reasons why the airbag light is on besides the obvious—if the car was in an accident—are clockspring and under-seat wiring (70% of the time).
What do I need to know about SRS control panel?
The SRS Control Panel is a program designed for adjusting the PC’s audio settings of the installed SRS premium sound card.
How to remove SRS control panel in Windows XP?
When you find the program SRS Control Panel, click it, and then do one of the following: Windows Vista/7/8: Click Uninstall. Windows XP: Click the Remove or Change/Remove tab (to the right of the program). Follow the prompts. A progress bar shows you how long it will take to remove SRS Control Panel. Error posting comment.
How can I Reset my SRS warning light?
It will tell you where the problem is and allow you to reset it once the problem is fixed. Our favorite scanner that will read and reset your SRS / airbag light is the iCarsoft i980 for Mercedes-Benz which will retrieve the SRS light but also the check engine.
How does the SRS warning system work in a car?
SRS Warning System. The SRS system checks the operation of several components in your car such as: Airbags. Airbag control unit. Crash sensors. Emergency Tensioning Devices. Belt force limiters. Child occupancy sensor in front passenger seat.
Can You unplug the SRS airbag control module?
You are now safe to unplug the airbag control module harness wiring plugs. All airbag srs components must be installed and connected properly before installing the airbag control module. This includes air bags, seat belts, clock spring and impact sensors. Disconnect the battery and bolt down the module and then connect the harness wiring plugs.
What happens to the SRS controller in a car accident?
When an accident occurs, the SRS airbag module writes codes in its memory that contain crash information. Once written, this SRS controller becomes “locked” until it is replaced or reprogrammed. This is due to the fact that the car will no longer be safe to operate.
Where is the SRS computer module in a car?
Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed. First find the srs computer module. In most cars it is under the center console that is between the two front seats, or center of the dash on the floor.
Do you have to pay for SRS reset service?
Just Plug & Play! This service is 100% compatible with our seat belt repairs. Some modules referred to as “MCU” modules will require additional programming and chip replacement. Such will incur an additional fee of $15. You agree to potentially be required to pay this up charge.