How tight should my front shocks be?
When installing new shocks, the goal is to tighten them just enough that there is no play or chattering in the suspension over bumps. But not so much that it adds any noticeable resistance to the shock’s pivot points. Or if you hear clicking at the bolt/shock, it’s too loose.
Where to find torque specs for struts?
2. Shouldn’t we re-torque the top 3 nuts to 59 ft lbs after the car is lowered to the ground? Since the nuts will carry the weight of the car, after it is lowered, the torque might be less than 59? 3. Similarly for the end links, we should just torque it to something like 15 ft lbs. Then at the end, drive it up a ramp and torque it to 29, correct?
What are the torque specs on a Subaru?
Subaru Torque Specs Values Number Torqs BOLT SIZE TORQUE SPECS Front Upper Strut Hats Nuts 3 M8 14.5 FT.LBS Front Upper Strut Hats Nuts 3 M10 22 FT/lbs Center Strut hat Mounting Toque 1 M10 41 ft-lb Lower (2) Strut Mount at Knuckle 2 M14 129 lb-ft
Which is the best front strut for your car?
Dials should be tested before installing. If you are looking to replace your vehicle’s front struts, Rancho RS999910 struts are the best option. They beat other struts with their features and price. Rancho RS999910 has been used by many people and gained a lot of positive reviews and thus gained the second place in our research.
How to install a lower strut on a car?
TWO LOWER BOLTS STYLE: • (Fig. 4) Remove and save lower mounting nuts (G) and bolts (H). Separate lower strut mount from steering knuckle. • (Fig. 1) Remove and save the bearing plate upper mounting nuts (A). (P-Pack included with new nuts.) • Remove the strut assembly from vehicle (Fig. 5, 6 & 7).
What is the torque on bolt on stuts?
Most bolts fastening the ball joints to the steering knuckles and control arms require a torque of just over 90 foot-pounds. The struts have upper mounting nuts tightened to 30 (rear struts) or 60 (front) foot-pounds; the bolts connecting it to the steering knuckle are around 155 foot-pounds and the damper shaft nut is around 35 foot-pounds.
What is the torque spec for the rear differential cover bolts?
From the factory service manual, it’s 30 ft lb torque, for the rear diff cover bolts. Re: Differential cover torque spec. Nov 27 2014, 5:00pm Most every guide I have seen shows roughly 30-35 lb torque for most diff covers.
What are the torque specs for a Chevy 350?
The specifications given are for the typical 350 engine. The Chevrolet 350 cylinder-head torque specification is 65 ft.-lbs. The intake installed onto cast-iron heads requires 30 ft.-lbs.