How do you replace a wheel bearing on a Mazda 3?
This job is a bit of a pain, and you also need to have a machine shop press the old bearing out, and press the new bearing in. Make sure that when the new bearing is pressed in, that the shop puts retaining compound on the surface of the bearing as per a TSB issued by Mazda.
Can a steering wheel be removed from a Mazda CX 5?
Mazda CX-5 Service & Repair Manual/ Suspension/ Front Suspension/ Wheel Hub, Steering Knuckle Removal/Installation CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake.
Can you replace wheel bearings on a Mazda Protege 5?
Wheel bearing replacement in a 2003 Mazda Protege 5. Press in style bearings done without using a shop press. Specific for Mazda Protege, but many of the techniques will apply to vehicles with pres-in-style wheel bearings. It’s a good idea to try to use the bearing-press-kit the way it was intended.
How do you repair the front wheel hub on a Mazda CX 5?
1. Remove the locknut. 2. Install a spare nut onto the drive shaft so that the nut is flush with the end of the drive shaft. 3. Tap the nut with a copper hammer to loosen the drive shaft from the front wheel hub. 4. Separate the drive shaft from the wheel hub. 1.
How to change the left front wheel bearing on a Mazda 5?
What is the procedure to change the left front wheel bearing on a 2007 Mazda 5. Can I do it without a press? … read more car started knocking loudly when I was driving home last night.
Wheel bearing replacement in a 2003 Mazda Protege 5. Press in style bearings done without using a shop press. Specific for Mazda Protege, but many of the techniques will apply to vehicles with pres-in-style wheel bearings. It’s a good idea to try to use the bearing-press-kit the way it was intended.
How to remove wheel support on Mazda CX-5?
1. Remove the wheel hub bolt using a press. Hub Support Bushing (Front) Removal Note 1. Mark the hub Support as shown in the figure. 2. Press the rear hub support bushing (front) out using the SSTs Hub Support Bushing (Rear) Removal Note 1. Mark the hub Support as shown in the figure. 2. Press the rear hub support bushing (rear) out using the SSTs
How to change front head light on Mazda 5?
Pull the front bumper ends (wheel arch) outward (1) to detach from the bumper slider. CAUTION: When disengaging the front bumper from the bumper slider, the front bumper could fall and be damaged. Secure the front bumper so that it does not fall. 2. Remove the front bumper from the body. Front Bumper Installation Note 1.
When did I replace the shocks on my Mazda 3?
I had the shocks/struts replaced all around about 6 months and 6,000 miles ago; for the fronts, the struts themselves, strut bearings and endlinks were replaced. Also replaced was the driver’s side axle (due to a f*ck up on my part when trying to replace the front suspension myself).
What does a bent wheel sound like on a Mazda3?
DrWebster- your problem sounds like tire wear caused by incorrect alignment/bent subframe, bent wheel, wheel out of balance.