Is there a warranty on a Mazda transfer case?
Mazda issued a bulletin in 2014 extending the warranty to 7 years or 90,000 miles but didn’t inform any of the customers of this problem. There is no service schedule for the transfer case as recommended by Mazda. Or any way I understand to change the lubricant in the transfer case.
Are there any problems with the Mazda CX9 transfer case?
Known issue of transfer case mechanical failure in all cx-9 models from 2007-2015. Transfer case is too close to exhaust causing the oil to dry up. Transfer case explodes causing the vehicle to lock up while driving. Known issue that has cause many accidents.
Why does the 4 wheel drive light stop flashing?
The transfer case neutral position needs to be selected before you attempt to engage 4WD. The selected position indicator light will flash until the transfer case completes the shift. When the shift is complete, the indicator light for the selected position will stop flashing and remain ON.
Where is the transfer case on a car?
Your transfer case, which is located right near your transmission, is responsible for taking the power that is generated by your vehicle’s engine and distributing it to all four of your vehicle’s wheels.
When to replace transfer case shift control switch?
You also have to diagnose the connector of the transfer case shift control switch and the ground circuit for ground. If the TCCM fails the self-test but all these circuits turn out fine, you have to replace the TCCM. It is normal to have this message sometimes. It goes away when you shut the vehicle off and then turn it back on.
How does the transfer case control module work?
As you already know, the TCCM controls the shifting in the 4WD system. But, how does it do that? The module determines the processing of the shift by using the speed of the vehicle and the real-time transfer case mode. if the shift is possible, the TCCM will complete it by activating the transfer case encoder motor.
The transfer case neutral position needs to be selected before you attempt to engage 4WD. The selected position indicator light will flash until the transfer case completes the shift. When the shift is complete, the indicator light for the selected position will stop flashing and remain ON.