How to install a Mazda Etude 160ie ignition harness?

We installed new ignition wiring harness it ran for a short time then blew starter now it starts in accessory position and winds up like someone slammed on gas … read more Chris (aka- Moose) Technician Vocational, Technical or Trade School 1,238 satisfied customers I just got a 1991 mazda pickup. It needs a fuel pump but

What’s the best way to wire an ignition source?

For FAKRA aerials, push the tabs in (youâll feel/hear a small click) and pull those off, be careful with these they can break easily. For ISO blocks depress the tabs on the side of each block and pull the blocks out. For ISO aerials just pull it off. Take your length of wiring cable, strip one end and crimp your male 15amp bullet to it.

How to wire an ignition to a stereo?

Once youâve established what is on the loom you need to use either your male/female 5amp bullet connector to connect to your new ignition wire. Strip the wire end, crimp your connector, and connect it to the stereo loom.

How many pins are on the harness and fuel injector?

The White (7 pin) connector wasn’t detailed on Josh’s diagram, as it seemed to just connected to standard engine connections. However, for some reason he’d relocated all but one of the pins to different parts of the connector. I found it much easier to remove the male pins on the other side of the harness to make the connectors match.

Where do you put the wiring harness in a car?

To start we routed all necessary wires to the rear of the car using the factory clips and trunk grommets. One important addition to note when installing any new wire harness is the incorporation of a wire loom or conduit.

Where can I get a new Charger wiring harness?

One of the first steps that needed to be done in order to get our ‘68 Charger project road worthy, was to replace what was left of an old, hacked up wiring harness with a new one from Speedway Motors. Again, the goal was to get our car drivable and do it on a budget.

How do you install a universal wiring harness?

After ripping out the old harness and cleaning up the connections that were still usable, it was time to install the new harness. We found it useful to lay out the entire harness and route each separate area at a time.

Can a Mazda Etude 160ie fit a Mazda 2.5?

Canuck Tech Associate 501 satisfied customers Will a mazda 2.5 engine wiring harness fit a Mazda 2.0 Will a mazda 2.5 engine wiring harness fit a Mazda 2.0 engine of the same year? a 1999 Mazda 626 to be specific… read more Juan Crespo Sr. Technician

Who is the best mechanic for a Mazda Etude?

Describe your issueThe assistant will guide you Chat 1:1 with a mazda mechanicLicensed Experts are available 24/7 100% satisfaction guaranteeGet all the answers you need Ask Chris (aka- Moose) Your Own Question Chris (aka- Moose), Technician Category: Mazda Satisfied Customers:1,238 1,238 Satisfied Customers

How long does it take to fix a Mazda Etude?

Answered in 11 hours by: 3/23/2012 Mazda Mechanic: al-mod, replied 9 years ago al-mod Category: Mazda Satisfied Customers:20 Verified Hi, I’m a Moderator for this topic and I wonder whether you’re still waiting for an answer. If you are, please let me know and I will do my best to find an Expert to assist you right away.

Navigation