What kind of interior does the Lexus RX 300 have?
The RX 300 interior featured leather trim, two rows of seating, and a rear cargo area which could be concealed beneath a tonneau cover.
How do you replace the thermostat on a Lexus RX 300?
Once the thermostat seat is cleaned, replace the new thermostat and gasket, securing it with the bolts originally removed. Figure 5. Old, leaky Lexus RX 300/330 thermostat that needs replacing. Once the thermostat has been replaced, re-install the water inlet.
Where does the serpentine belt go on a Lexus RX?
This article applies to the Lexus RX (2007-2014). Traditionally, a serpentine belt goes around all the different pulleys on the front of the motor, thus giving it it’s name from the serpentine route it takes. However, the Lexus RX’s are a bit different and have two different belts: one for the power steering and one for the alternator.
What was the drag coefficient of the Lexus RX 300?
The exterior color scheme was two-tone, with the bumper and lower body-side cladding a gray color. The RX 300 carried a drag coefficient of 0.36 Cd. The first-generation Lexus RX was built in Kyushu, Japan.
How to replace air mix Servo on Lexus RX300?
Direct replacement. Took about 30 minutes to replace. A little tricky to get back screw out. Remove glove box and side panel Remove small air duct and servo is right there. Put mine on 2002 Lexus RX300. Fits perfect. This allows you to go from heat to cool. The other servo controls where the air comes out.
What kind of heater does a Lexus RX300 have?
Put mine on 2002 Lexus RX300. Fits perfect. This allows you to go from heat to cool. The other servo controls where the air comes out. Make sure you get the correct one. On google I read instructions on how to install and watched a couple videos on u tube. they pointed out the problem areas and how to work them out.
What does the ECU do on a Lexus?
This article applies to the Lexus IS, GS, RX, ES (2004-2014). The engine control unit, or ECU, is basically the brains of your car. The ECU stores diagnostic trouble codes when it senses a malfunction so a mechanic can fix it later. It’s also the ECU’s job to store your driving data to customize your ride.
Where is the fuse puller on a Lexus ECU?
If your fuse box doesn’t have the fuse puller in it, you can use pliers for the next step. Using the diagram on the bottom of the fuse box cover, remove the EFI fuse and ETCS fuse.