Where are the timing marks on a Lexus water pump?
The left cam pulley has double lips vs. the right cam pulley has single lip. The cam pulleys also has reference mark as L or R. U should mess them up. The two marks are clearly defined at the pictures below. The timing marks are located in front of the pulleys. The picture below on the left clearly show the timing reference marks.
How do you change the timing belt on a Lexus?
I put the 22mm socket with a wrench and placed it in a loosen position. I placed the handle next to the frame in the passenger side and crank the starter. I am using the starter power to turn the bolt. After two turns, the bolt came loose. It’s almost like magical.
Where is the timing trigger on a Toyota water pump?
The cam timing trigger is located at the rear of the pulley. Here is a picture of the Left Cam reference on the timing belt aligned with Left Cam pulley. If you can get all three marks in the proper position, then u can continue to install parts back.
Do you need special tool to replace Lexus water pump?
Lexus mentioned about the special tool, but you would need at least 3 to 4 feet extension in order to have enough leverage. I also tried air gun and failed. The cheapest and fastest was would be the “Old School” method. Yes, that is right ” No school like the Old School”
Where is the timing belt on a Lexus LS400?
41) Check to make sure the timing marks on both camshaft timing pulleys line up with the marks on the engine (white marks), then pull on the belt and install it onto the LH camshaft timing pulley. The “L-CAM” line on the timing belt should run right in between the marks.
The left cam pulley has double lips vs. the right cam pulley has single lip. The cam pulleys also has reference mark as L or R. U should mess them up. The two marks are clearly defined at the pictures below. The timing marks are located in front of the pulleys. The picture below on the left clearly show the timing reference marks.
How do you change the water pump on a Lexus LS400?
Use a strong screwdriver or pry bar between the water pump and cylinder block to pry it off, be careful not to damage the block. Clean all the old sealant, grease, coolant, and dirt off the cylinder block. Here’s what it will look like with the water pump removed and everything cleaned up. 29) Replace the O-ring on the water by-pass pipe.
The cam timing trigger is located at the rear of the pulley. Here is a picture of the Left Cam reference on the timing belt aligned with Left Cam pulley. If you can get all three marks in the proper position, then u can continue to install parts back.
What to do if your Lexus timing belt gets stuck?
FYI, when you remove the two Distributor Caps, they might get stuck due to time. Use a flat screw driver and pry it out. When u buy original timing belt from Lexus, the belt itself has three reference points. Here are the three reference points: Here is the tricky part and I will try to explain it very carefully.
How much does it cost to replace a Lexus timing belt?
Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM. Lexus LS400 Timing Belt Replacement costs $895 on average.
What happens if the timing belt breaks on a LS?
The first gen LS’s (1990-1994) have a non-interface engine, so if the timing belt breaks it’s not going to damage the engine. If it breaks you’ll just be stranded. Some belts break and some last. Timing belt & water pump parts kit There are several kits like this one available for this job.