Is there a way to fix an amplifier with no sound?
After spending some times to check the circuit board, I can’t believe that there were actually 15 bad components found which include the burnt resistor. After the replacement with new components the stereo power amplifier with no sound problem was finally fixed. I did not post the video thus you would not hear the sound but the sound worked!
Why does my audio system have no sound?
No sound has two possibilities. 1)software, or 2)hardware. You could have BMW update the software on the car and see if that fixes it. If not, it’s likely a hardware failure. I didn’t see if you have the I drive, or just the radio.
What do you do when there is no sound coming from your radio?
Started the car, pulled the fuse, waited one minute, turned OFF the car, put the fuse back in, restarted the car. Everything worked great. BTW, it is the 20A Multimedia Fuse on the 2013 Elantra Ltd. 59 people found this helpful. Paper clip also worked For 2012 Elantra Ltd.
How to repair TAC integrated stereo power amplifier no sound?
A customer of mine brought to me the TAC Integrated Stereo Power Amplifier With the Model of AV-355 for repair. The complaint was no sound but have power. Usually the first thing I do was to connect a speaker at the output jack to see if the sound really not present. Another test is to check the output DC voltage at the speaker output jack.
What to do if your amp makes no sound?
If your amp makes no sound, it is first important to define what you mean by “no sound.” To that end, the first test you should perform is whether you can hear anything coming from the speakers. (This is, of course, after you have eliminated the possibility of trivial problems .)
What kind of sound does a no sound AMP make?
Usually, in a no-sound scenario, you will hear some sound coming from the speakers, even if the signal path happens to be cut off. For instance, you may hear hum, hiss, reverb crash (if applicable), or even popping sounds when connecting or disconnecting inputs.
Why is my radio on but no sound from the trunk?
Both radios come on, and can change screens, and the back up camera works too. This is a VAN, so there isn’t any amp in the trunk. No sound in any of the speakers. The connections to the car wiring are good, and even blew out the connections with compressed air to ensure a clean seating with the wiring.
No sound has two possibilities. 1)software, or 2)hardware. You could have BMW update the software on the car and see if that fixes it. If not, it’s likely a hardware failure. I didn’t see if you have the I drive, or just the radio.
After spending some times to check the circuit board, I can’t believe that there were actually 15 bad components found which include the burnt resistor. After the replacement with new components the stereo power amplifier with no sound problem was finally fixed. I did not post the video thus you would not hear the sound but the sound worked!
What to do if your car stereo has no sound?
Radios have all sorts of wires going in and out of them. Each wire serves a specific purpose for the car stereo to operate correctly. If you have a car stereo that has no sound than we should start by checking that all the wires are hooked up. A car stereo will always have 3 different power wires going to the deck section.
A customer of mine brought to me the TAC Integrated Stereo Power Amplifier With the Model of AV-355 for repair. The complaint was no sound but have power. Usually the first thing I do was to connect a speaker at the output jack to see if the sound really not present. Another test is to check the output DC voltage at the speaker output jack.
Why is my radio on but no sound?
The stereo suddely makes no sound (not even hiss/noise) It appears to be working fine (reception of radio signal fine, plays cassettes, etc…) but no sound what soever. I h … read more My radio one day was on and then off a sudden took a crash. My radio one day was on and then off a sudden took a crash.