What causes a CD player to have no display?
7.1.2) CD player is operational but there is no display or partial display. Possible causes: 1. Burned out back-light bulb(s). 2. Bad connections to display panel (totally dead or erratic).
Why is the radio working but no display?
The radio works fine just no display.. Now we are being told it is possibly the radio itself that needs to be replaced. Did you have any luck fixing your display? I have Fusion 2013 SE. and the same problem.. so upset.
Why does my CD player send back a ” no disc ” message?
(I’m out of canned air.) The player turns on and the radio works fine, but every cd spins for a moment and then gets the “no disc” rejection. I can’t find out much information anywhere else.
Why is my compact disc player not working?
Possible causes: 1. Bad connections to one or more buttons or sets of buttons. 2. Microcontroller failed to reset properly. 3. Missing/bad voltages from power supply. 4. Defective microcontroller or other logic. 7.1.4) Drawer does not open or close. Possible causes: 1. Worn, stretched, oily, flabby, belt. 2.
The radio works fine just no display.. Now we are being told it is possibly the radio itself that needs to be replaced. Did you have any luck fixing your display? I have Fusion 2013 SE. and the same problem.. so upset.
What to do if your CD player says no disc?
12.3 Replace the two screws on the left (17) that secure the matrix assembly to the base and the two screws (17) that secure the transformer (5) to the matrix. 12.4 Lower the CD mechanism into the matrix assembly (8) so that the cables are toward the right speaker. 12.5 Lower the display PCB into the slots located on the matrix assembly.
How to change display PCB on CD player?
3.3 Remove the ribbon cable that connects the CD door (7) to the display PCB. Remove the two ribbon cables that connect to the main PCB. Lift out the display PCB. Caution: If you remove the ribbon cable from the CD door, you might have difficulties reconnecting the cable. 4. Display PCB Replacement
What to do if your Harley Davidson radio is not working?
If no switches are found to be shorted to B+ or ground, you may press selected switches to verify functionality (vol. Up/down – mode – etc). If a switch is functioning properly, the display shows the switch, name and the word “OK.” If the switch is not working correctly, the display does not change.