Where is the hub located on a wheel?
The rim is the outer part of the wheel that holds the tyre. A hub assembly contains the wheel bearing and hub to mount the wheel to vehicle. It is located between the brake rotor and axle. II. METHODOLOGY OF PRODUCT DESIGN Product design is one of the most important and sensitive factor for an organization.
How are front hubs used for weight reduction?
This work is based on the design and analysis of front hub for weight reduction and increase the strength of hub by the help of Nastran / Patran. The weight and dimension of the hub must be as small as possible because of the un sprung weight which further reduce the rotational mass.
How big is the shaft on a Ford spindle?
Ford Spindle, Right Hand – This spindle has a vertical Shaft that measures 12.125 inches in length with a top diameter of 1.244inches and a bottom diameter of 1.465 inches. For 4000. The wheel bearing kit used for this spindle is part number WBKFD5.
When does a wheel hub need to be replaced?
A good hub assembly should have close to zero lateral movement. If the wheel and tire assembly easily move back and forth, the hub is bad and must be replaced. There are several ways to inspect a wheel hub assembly.
What kind of hub assembly does front wheel drive car use?
On cars made before 1997, front wheel drive cars use wheel hub assemblies at each wheel and rear wheel drive vehicles use two individual bearings and seals in both front wheels. Unlike a wheel hub assembly, bearings can be serviced.
Where does the spindle go on a 4WD steering wheel?
The drive axle on FWD/AWD/4WD vehicles extends through the knuckle and is attached to a hub that is bolted to or pressed into the knuckle. Certain 4WD trucks have a hollow spindle that bolts to the knuckle, through which the drive axle extends and on which the hub rotates. The precursor of the modern steering knuckle and spindle was the kingpin.
Is the spindle part of the drive axle?
On RWD vehicles the spindle may be an integral part of the knuckle, to which a hub with tapered roller bearings is installed, or a hub with sealed bearings may be bolted to the knuckle. The drive axle on FWD/AWD/4WD vehicles extends through the knuckle and is attached to a hub that is bolted to or pressed into the knuckle.
What kind of hub does a trailer spindle use?
Round R20484X 84 Spindle & 5-4.5″ Bolt Circle Trailer Hub. 5 studs 4.5″ Bolt circle using L68149 inner and L44649 outer bearing hub. (84 Spindle). Hubs are pre-raced & pre-studded with 1/2″-20 studs. Includes Hub, inner bearing, outer bearing, seal, grease cap & lug nuts.