What should tire pressure be on Kia Niro?
> 0.07 kgf/cm? (1.0 psi) additional injection at the specified tire pressure. > 0.28 kgf/cm? (4.0 psi) additional injection at the specified tire pressure. In case the warning lamp fails to turn OFF after injecting tire pressure, disconnect the KDS/GDS and drive less than 1 km at 25 km/h.
Do you need a calibrated air pump for Kia Niro?
You really need to have a calibrated air pump to set the pressure on the pump. Trying to hit the exact pressure looking at the dash was a pain. Yeah I think your expecting the TPMS to do too much.
How do you open the sunroof on a Kia Niro?
To open the sunroof Push the sunroof control lever upward until the sunroof moves to the desired position. To close the sunroof Move the sunroof lever forward until the sunroof moves to the desired position. WARNING – Sunroof Be careful that someone’s head, hands and body are not trapp …
How to check tire pressure with Kia Cee’d?
Turn IG OFF and then IG ON again to check the warning light type. 2. (1) Check the warning lamp state. Check the vehicle warning lamp state. Check if the warning lamp state is caused by tire low pressure. 3. (2) Check the warning lamp state. Check the vehicle warning lamp state.
What’s the tire pressure on my Kia Niro?
Pressure reading on car is right on with a regular tire gauge. Right now I have 37 front and 38 rear (cause I set rear pressures before a Thanksgiving Trip when had car loaded and I had noticed one tire down a couple pounds from the others).
How does TPMS work on a Kia Niro?
The TPMS malfunction indicator is combined with the low tire pressure telltale. When the system detects a malfunction, the telltale will flash for approximately 1 minute and then remain continuously illuminated. This sequence will continue upon subsequent vehicle start-ups as long as the malfunction exists.
When to check tire pressure on Kia Sorento?
If any of the below happens, we recommend that the system be checked by an authorized Kia dealer. 1.The low tire pressure telltale/ TPMS malfunction indicator do not illuminate for 3 seconds when the ignition switch is turned to the ON position or engine is running.
You really need to have a calibrated air pump to set the pressure on the pump. Trying to hit the exact pressure looking at the dash was a pain. Yeah I think your expecting the TPMS to do too much.