How do you tighten up a serpentine belt?
Another tensioner pulley uses a square-faced bolt for adjustment, and a third uses a large tab that can be set to a certain position for proper belt tightness. To remove an old serpentine belt, or to tighten up a new one, the tensioner bolt on the tensioner pulley is turned until proper tightness is achieved.
Can a serpentine belt be removed from a Hyundai?
Once the bolts are loosened, the alternator can be pushed downwards, which will loosen the serpentine belt. Remove the serpentine/drive belt from the pulleys. Install the serpentine belt in reverse order. Ensure that the belt is routed properly and that the belt is sitting correctly in all the pulleys.
Why is my serpentine belt not working properly?
If you find that the belt is not in bad condition, you should still inspect the tensioner, but it could be another problem, like a broken pulley. Typically, the smooth back of the serpentine belt powers the water pump. If the serpentine belt is glazed or oil soaked, the engine will not be cooled as required.
Can a serpentine belt be installed in reverse order?
Install the serpentine belt in reverse order. Ensure that the belt is routed properly and that the belt is sitting correctly in all the pulleys. The serpentine belt is also called the drive belt, poly v-ribbed belt, or accessory belt.
What’s the best way to replace a serpentine belt?
Auto tensioners have either a hole that will fit a half inch drive ratchet, or a bolt you can use a socket to apply pressure to. Insert the wrench or place the socket over the bolt on the tensioner and twist it away from the belt to relieve the tension on it.
How is the tension set on a serpentine belt?
Depending on the application, your serpentine belt will either have tension placed on it using a movable bracket or an auto tensioner pulley. This pulley uses an internal spring to apply consistent pressure to the belt at all times. If your vehicle does not have a tensioner pulley, the alternator bracket is likely how tension is set on the belt.
Can a car run without a serpentine belt?
However, these devices cannot function properly without the help of a serpentine belt. This one long continuous belt is the force that drives many of the engine’s peripheral devices. There is usually a belt tensioner or idler pulley to guide the belt as it moves. What is a Serpentine Belt? What is a Serpentine Belt?
How do you remove the serpentine belt on a Toyota Camry?
There are two 10mm bolts that need to be removed. Figure 2. Inner fender liner removal. Label and save your bolts so you know where they go during re-installation. Remove the serpentine belt by turning the 19mm bolt on the tensioner clockwise.