How do you read the voltage on an oxygen sensor?
The greater the difference, the higher the voltage reading. An oxygen sensor will typically generate up to about 0.9 volts when the fuel mixture is rich and there is little unburned oxygen in the exhaust. When the mixture is lean, the sensor’s output voltage will drop down to about 0.1 volts.
What does the code p0138 mean on the O2 sensor?
What the P0138 code means. P0138 is the OBD-II generic code indicating the O2 sensor for bank 1 sensor 2 fails to have a lower voltage output below 1.2 volts for more than 10 seconds indicating a lack of oxygen in the exhaust stream.
What does p0138 mean on a Jeep Wrangler?
Users have reported P0138 for the following makes: Jeep (especially on a Jeep Wrangler), Dodge, Toyota, Nissan, and Chevrolet. Code P0138 means that your powertrain control module (PCM) has detected that the voltage signal from the rear O2 sensor is too high. What is an Oxygen Sensor? All modern cars have at least two oxygen sensors.
How can I tell if my Cherokee has an oxygen sensor?
It is possible to diagnose the P0138 with a multimeter. If you use the multimeter, you’ll know whether or not the voltage coming to and from the oxygen sensor is within spec, this can help you determine if it’s your Cherokee’s O2 sensor, or wiring harness that’s the issue.
What is the OBDII code on a Jeep Cherokee?
P0138 is a common OBDII code that occurs in many vehicles, including the Jeep Cherokee. The code is triggered when: The voltage at the sensor remains above threshold for 20 seconds or more There are also some less likely problems that can cause P0138. We’ll go over those below. Here’s a pretty helpful video from AutoEclinic on diagnosing the code:
What does code p0138 on O2 sensor mean?
A code P0138 may mean that one or more of the following has happened: 1 Faulty O2 sensor 2 Short to battery voltage in O2 sensor signal circuit 3 High fuel pressure (not as likely)
Users have reported P0138 for the following makes: Jeep (especially on a Jeep Wrangler), Dodge, Toyota, Nissan, and Chevrolet. Code P0138 means that your powertrain control module (PCM) has detected that the voltage signal from the rear O2 sensor is too high. What is an Oxygen Sensor? All modern cars have at least two oxygen sensors.
What causes the p0132 code on a Jeep Cherokee?
Here are the most common issues that cause the P0132 code in the Jeep Cherokee. They are presented in order (somewhat) of most to least likely to cause the problem. Bad Oxygen Sensor – The O2 sensor itself is one of the most likely reasons that P0132 is triggering your service engine soon light.
P0138 is a common OBDII code that occurs in many vehicles, including the Jeep Cherokee. The code is triggered when: The voltage at the sensor remains above threshold for 20 seconds or more There are also some less likely problems that can cause P0138. We’ll go over those below. Here’s a pretty helpful video from AutoEclinic on diagnosing the code: